Auto Parts and Repairs
Ford Taurus
Saturn S-Series
Chevy Prizm

How do you replace the piston rings on a 1995 Saturn SL2?

202122

Top Answer
User Avatar
Wiki User
2007-04-13 14:17:01
2007-04-13 14:17:01

Saturns have a design defect, and the piston rings are part of a complete engine overhaul. $$$$$ You'll want to flush out the carbon that builds on the piston rings, that causes it to consume oil... I'm doing my radio show tomorrow (Sat 14th 9AM pacific), and if you call in and be my guest for an hour, I think this would be a good topic for tomorrows show... please email me if your available to call...:) Dave cartalk@fastmail.fm

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The Rings of Saturn was created in 1995.

User Avatar

Remove engine, disassemble, replace piston, re-assemble engine and install. Good times!

User Avatar

Need instructions on how to replace a manual window regulator on drivers side on 1995 saturn

User Avatar

A home mechanic could do this for less than $1000 but he would be skipping many performance and reliability repairs as he has the engine apart.

User Avatar

Remove the positive cable from your 1995 Saturn battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.

User Avatar

2 possiblities: 1) worn piston rings, or 2)leaking valve seals

User Avatar

http://www.youtube.com/watch?v=_n76-CqvJ2k richpin

User Avatar

Replace the engine coolant temperature sensor. Your car has two, replace the one with the 2 wire connector

User Avatar

Loose or damaged oil drain plug; Plugged or damaged pcv valve; Worn or broken piston rings.

User Avatar

Check saturnfans.com forums under the SL or post the question.

User Avatar

Open the hood it pops into the backside of the lens.

User Avatar

The SDM in the 1995 Saturn is located under the center console.

User Avatar

The PVC valve is not held in by any nuts or bolts. Just pull on it to remove it.

User Avatar

check link below,this is for a gen 2 but is very similar to your gen 1.

User Avatar

Saucer to Saturn was created in 1995.

User Avatar

The minimum price for a 1995 Saturn SC1 trailing arm is $50.

User Avatar

Since it's very difficult to get to the clamps underneath the hood, I recommend working from inside the car. Remove the cover from underneath the center of the dash.Remove the bolt holding the heater-core tubes, which are attached with snap rings.Remove the snap rings.Grease the "o" rings in the tubes before reassembling.Replace the heater core.Replace the snap rings and cover.Drain and replace the coolant bleed system.

User Avatar

Inside the fuel tank. You'll need to lower the tank to replace the fuel pump.

User Avatar

Code 45 is an Injector leak. You can replace the injectors or just the O-Rings.

User Avatar

you take off the door pannle and it will be right behind the mirrior three screws

User Avatar

Replace the blinker relay, located on the fuse panel. Buy it at any automotive parts dealer.

User Avatar

my 1995 Saturn sl2 has a factory alarm, my daughters 1997 sc1 also has one


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.