Hey Stacy==It isn't the easiest thing to do and you need special tools. I suggeast you take it to the trim shop. GoodluckJoe
The only special tool you need is a trim panel remover tool that you can buy for under $10. See my related link for full instructions on how to do the repair.
dude take it to safelite you ain't gonna figure it out just gonna give your self a headach btw its called a panel poper and its called a door panel nice try though
yea it's a door panel, but the tool is a trim panel remover.
you prolly need a new window motor... check a local junkyard.
replace the power window motor inside the door. You will have to drill out the rivets and replace with nuts and bolts
I can't tell you precisely, but you'll see it when you pull the inside door panel off to access it.
Goto www.car-parts.com and look up and engine in the list it will tell you all the cars that have that motor
video on how to replace window lift motor on j30
Remove the window regulator and motor from the door as an assembly. Drill out rivets that hold motor to regulator and replace motor. Regulator needs to be riveted back into door for reassembly
Try this link, http://www.a1electric.com/grandam.htm. It shows how to replace the entire window regulator assembly (which includes the motor). Probably the cleanest description I have found.
Me and two of my friends have had problems with one or another window not responding, every time it was the actual switch in the center counsel that went out
http://www.energysuspension.com/forum/index.php?topic=12.0 Found this real fast. It tells you how to replace the motor mount insert, but explains how to replace the whole thing as well.
How to remove the window motor from the regulator
the power window motor is probably bad
replace a window lift motor for a 2002 gmc sierra?
replace 1987 dodge pickup/power window motor
The Blower Motor Resistor Pack is defective. Replace it.
when replacing motor what position does the window need to be in?
don't just replace the window motor replace the whole car. get a hybrid or something
The 1997 Chevrolet Cavalier motor will fit into the 1997 Pontiac sun fire. The motor mounts and the wiring harness are exactly the same.
You can find quite a bit of info about Sunfires at this website http://consumerguideauto.howstuffworks.com/1995-to-2005-pontiac-sunfire-6.htm FriPilot
Your wiring is probably messed up, happened to me. Locate the wires from the blower to the controls check them and replace as needed. Assuming no wiring problem check and replace the blower motor resistor.
The window motor is attached to the window regulator by screws. After removing the door trim you must detach the regulator from the door by drilling-out four rivits. Then remove the screws from the old motor and install the new motor. Re-attach the regulator with bolts and put the trim back on the door.
I have a 1990 Pontiac Transport SE, I have the changed the motor on the driver's window which is power...take off the door panel and you will see the motor...not too difficult of a job...follow the old motor route...
HOW DO I REPLACE WINDOW REGULATOR MOTOR ON PASSENGER SIDE WINDOW
technically yes, it will fit. Whether or not it's worth the hassle is up to you.
i have a 2001 pontiac sunfire antitheft problem will not start anttheft light flashs on dash i can turn motor over buy jump starter but will not start