Electric Windows
BMW 3-Series
Saturn S-Series
Nissan Altima

How do you replace the power window switch on a 2000 altima?

171819

Top Answer
User Avatar
Wiki User
Answered
2011-09-12 21:01:49
2011-09-12 21:01:49

i have a 2001 Nissan altima and the power window switch had a problem... only the drivers window had a problem. I took it to the dealor b/c there is a recall on the power window switches and they replaced all 4 for free. Not sure if the 2000 year has the same recall, but it's worth checking out.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.

How do I replace the power window switch on 1977 Corvette coupe

Your switch could be worn out you would have to replace the rocker to the switch or replace the whole window switch console.

The led light in the window switch is not replaceable. It is only serviced with the entire switch.

Do you mean the main switch by the driver or the switch on the door itself?

I just replaced the power window switch in my 98 Nissan Altima and it is very simple. I slide a flat blade screwdriver under the front edge of the housing pushing in the clip. Pulled up on the switch housing assembly. Unplug the connector and plug the new switch assembly in place. I bought a factory switch online from an autoparts warehouse for about $90 including shipping.

First test to see if the problem is the switch, wiring, or the motor. Here's howhttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/test-power-window-motor-and-regulatorThen replace the regulator if the switch and wiring test good. Here's howhttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-motor-regulator

pry out the control switch and disconnect the electrical connectors.install is reverse.

Do you mean for the door or the main switch on the driver's side? The main switch is very easy to replace... not sure about the door switches.

The switch is burned out. Replace it.

A power window relay switch relays the power from the car's battery, to the switch itself, and then to the window motor. When pressing the button inside of the car it allows the power to go from the relay switch to the motor and roll the window up or down.

Broken regulator. REplace it. Here's how:http://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-motor-regulator

you must determine weather the switch or window motor is bad and replace.

you should be able to take the cover off the driver's door by unscrewing it,then unplug the window switch and replace it,fairly easy..

sounds like you need to replace power window master switch

If you mean the extra switch on the drivers side power window control it cuts power to the passenger side window switch. Handy if you have kids.

In the middle, you must pop out the faceplate that the switch is attached to. This can be done with a common screw driver. From there you will see that it is attached to power, unhook that and replace it with the new one. done.

Remove the door panel. Remove the switch retainer. Remove the wiring harness. Reverse the process to install the new switch.

in the hand part where you close the door theres a screw, take it off, pull the assembly from the top by the window switches, when it comes out the wires will follow, disconnect the harness, and replace with the new power switch. (note this is the drivers side)

The cable has slipped off a guide or is broken. The regulator is toast. Replace it. Here's a post on how to do it.http://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-motor-regulator

it rolls the window up and down, but that's not the problem. it's your window switch, very easy to replace and not exspensive at all, it's a plug in part

where is the fuses for the power windows

the switch is on the door panel approx four inches from the window, this is the only switch that sends power to the window regulator motor (window motor).

You are going to have 2 things to repair with this problem. The window switch and the window motor. The weak motor has melted the inside of the switch. Yep...been there,done that.Replacing the motor wont fix the switch and if you replace the switch the weak motor will melt the new switch.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.