Remove the cooling fans then take the hoses off and the cooling lines off. Then remove the bolts that hold it on and take it out.When you remove the lower hose catch the coolant in a drain pan and dispose of it correctly.
The brake rotor specs for 93 Toyota corolla the outside diameter 255 mm and inside diameter is 142.2 mm.
The curb weight of a 1993 Toyota Corolla is just over 2,300 pounds. The Toyota Corolla also has the lightest weight motor of other cars for its size.
how to replace rack end of Toyota corona 93?and the tools also tnx
is under the hood were the fuse box is.
it is located at the top of the clutch pedal it. it is removed by losening a nut and disconnecting the harness and it should just pull out
Yes it can..do a diagnostic
93-95 same hood grille chnge in 96 then headlights you can mix n match to create your own thing
The thermostat on a 1993 Toyota Celica can be found by following the outlet radiator hose. The thermostat on these cars are located at the bottom of the radiator.
Look here: How do you change the starter on a 1996 Toyota Corolla?Prizm and Corolla engines are the same.
remove the radiator, then remove 4 screws that holds the fan ,,done..
On a 1993 Toyota Camry Vienta, the thermostat can be easily located by following the lower radiator hose to the point where it attaches to the engine. When replacing the thermostat, always replace gaskets as well.
Both. The reservoir is the overflow. But in the event your radiator is low, your reservoir will back it up.
To change the turn signal flasher on a 1993 Toyota Corolla, locate the flasher unit under the dash on the driver's side. Pull out the old flasher plug and replace with a new one. This part has a three-prong plug that can be removed without hooking up or unhooking wires.
96 and 97 Corolla and Prizm are the same, but, they have an extra crankshaft sensor, that the 93, 94, and 95 does not have,
Yes!!!!!!!!! Everything bolts up, did it , bought a 1.6 by mistake, and it had a 1.8, and could not return it, so I put it in and it worked Great!, Drove it from Naples Florida, back to Milwaukee, WI, and it was Great, no issues, no lights, sold it and they are still driving it no problems
4 inch is what I have have found so far searching the net.
The stock speakers in a 1993 Toyota Corolla measure 4 inches in the front and 6 1/2 inches in the rear. The front speakers are located in the dash, and the rear speakers are located in the rear deck.
about $900.00 at a garage
You could install a turbo charger, a newer more advanced motor, or use NOS.
A malfunctioning brake light relay switch will cause your 1993 Toyota Corolla brake lights to stay on all the time. The brake light relay switch is located beneath the drivers side dashboard.
99.9% you cannot do that. Toyota parts are not compatible with Honda parts. Radiator & starter no way will the fit. Alternator it is possible if the mount is the same.
I am 100% sure that the rear springs from a Camry can fit a Corolla (case in reference 93' Camry springs on 90' corolla)but I haven't tried the front springs yet so I am not sure about that one
They pop off. You use a screwdriver or some type of panel removing tool.
If you're looking for the master window switch. It's located on the drivers side door pull or arm rest.