answersLogoWhite

0

  • Nissan Pathfinder
  • Bumpers

How do you replace the rear bumper on a 1998 Nissan Pathfinder?

User Avatar

Wiki User

βˆ™ 2006-10-16 12:52:34

Best Answer
Copy

There are mounting brackets that can be removed with either one or two big nuts underneth the bumper but to tell ou the truth some times when the bumper is so bad with rust its easier to just cut it apart BUT make sure you save the plastic and the frame that goes around the lisences plate good luck and if all else fails get a bigger saw LOL

2006-10-16 12:52:34
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Add your answer:

Earn +5 pts
Q: How do you replace the rear bumper on a 1998 Nissan Pathfinder?
Write your answer...
Submit

Related Questions

How do you remove a bumper from a 1998 Nissan altima?

How to remove the front bumper to a 1998 Nissan Altima?


Where can you get a rear bumper for a 1998 pathfinder 4x4?

JUNKYARD


How do you replace the flasher relay on a 1998 Nissan Pathfinder 4WD?

To replace the flasher relay on a 1998 Nissan Pathfinder 4WD, unplug the old turn signal flasher and plug in the new one. It is a three prong plug located under the dash on the driver's side. The hazard flasher relay works the same way.


How do lower the spare tire on a 1998 Nissan pathfinder?

can I move my spare tire thats on the back of 1998 pathfinder to under the vehicle


Does a 1998 Nissan Pathfinder have a speedometer cable?

No, this Pathfinder does not have a speedometer cable. It has a speed sensor on the transfer case.


How do you remove crankshaft pulley bolt from a Nissan Pathfinder is it right or left hand thread?

1998 Nissan pathfinder crankshaft pulley bolt is right handed.


When to replace rear universal joint on a 1998 Nissan Pathfiner?

The rear universal joint on a 1998 Nissan Pathfinder should be replaced when it becomes worn out or broken. Symptoms of a worn joint include rough handling and suspension issues.


1998 Nissan Pathfiner the speedometer and heat gauge quit workin?

1998 Nissan Pathfinder the speedometer and heat gauge quit workin?


How do you replace struts on a 1998 Pathfinder?

Take it to a mechanic yo!


How to replace a 1998 zx2 headlight?

the bumper will have to be removed.


Where is the speed sensor located on a 1998 Nissan Pathfinder Automatic?

It is located in the transfer case!


Is it difficult to change the oil filter on a 1998 Nissan Pathfinder?

no only two minutes


What is the tire size of tire of a 1998 Nissan Pathfinder?

265 70 R 15


Where is air temp sensor located 1998 pathfinder 3.3?

Behind the center of the front bumper, below the rad.


What does this havoline oil filter tfc-521 fit?

Nissan Pathfinder LE 1998


What is the wiring color for an amplifier for a pathfinder 98?

The wiring color code for an amplifier in a 1998 Nissan Pathfinder is blue or blue and white. This is the amplifier turn on wire.


Does Nissan Pathfinder 1998 is a timing chain?

It has a timing belt which must be changed every 106,000 miles.


How do you replace a 1998 Nissan Frontier fan clutch?

On


Why would your 1998 Nissan Pathfinder not fire after installing a new distributor?

Check if there is spark and that you have properly installed distributor.


How to fix the 1998 pathfinder lighter in center console which has no power from the plug but the fuse is not blown?

Replace socket Replace element


How do you replace the rear bumper of a 1998 Acura Integra?

very carefully lol


How do you replace the front bumper on a 1998 S70 Volvo?

The 1998 Volvo front bumper is held in place with eight retaining bolts. Remove the retaining bolts and the front bumper will come off. Reverse the process to install your new front bumper.


How to remove the bumper off a 1998 Nissan Frontier?

You must remove the bolts that connect the bumper to the frame from underneath the rear of the truck. Have someone hold the bumper so that it does not fall on you when you remove the bolts.


Replacing all rubber molding on 1998 Nissan Pathfinder?

To replace all of the rubber molding on a 1998 Nissan Pathfinder, a person will need to purchase a special glue along with the rubber molding. This can be purchased at the local automotive parts store. The rubber molding is usually sold in a kit for specific areas on the car, like the rear door hatch. Some rubber molding might have to be purchased through the manufacturer of the vehicle.


Replace Front and rear struts on 1998 Nissan Maxima?

how much is it going to cost me to replace the back struts on my Nissan maxima