Depends upon what year the vehicle is. They all have a series of screws holding the lens/assembly in. 1982 and prior (K5 Blazer) are visible from the vehicle's exterior. 1982 through 2004 (S-10 style) have a series of screws on the inboard side of the assembly.
how do you replace dome light in s10 chey blazer?
Your 2004 Chevrolet trail blazer and battery light indicator is always on because the battery has sufficient charge.
As per the instructions on page 5-55 of your "Owner's Manual"...
Remove screws, remove light assembly, rotate bulb holder counterclockwise & pull out, replace bulb(# 194). Installation is reverse.....
If a 1991 Chevrolet S10 Blazer warning brake light always stays on, it could just be a malfunction of the light. To reset it, disconnect the battery for 10 minutes.
The entire amber turn signal assembly will pop out. You will sometimes need to push from behind it while you or an assistant pulls from the outside to avoid breakage on brittle plastic. Once out just unscrew the bulb and replace it....1930fcoupe
Remove plastic grill.(screws on top,snaps at bottom)Now you can easily see the 4 bolts that attach each light housing.Remove lights, reverse order to replace.
if you have a chip in your key then the chip is bad
recall contact Chevrolet dealer
On a 2012 toyota Highlander, How do you replace tail light Assembly
Open the hood, remove the two tabs that lock the headlight assembly in place, remove the headlight assembly, doing this will give you access to the signal light socket for bulb replacement.
unsrew the main bolt and pull