first you remove the tire and then brake drums. You will see the wheel bearing and hub assembly with the 5 lugs facing you there should be four bolts you gotta take off which is pretty hard to break them loose use caution not to get hurt. Once you get them off if your lucky the hub will slide off if not you gotta pry it loose. Then you just put the new one on and repeat your steps in reverse. If you want better detail ask the same question on automotivehelper. Com there are tons of olds questions that everyone answers so you will get answers fast by a lot of people I use it all the time it is the best site hands down good luck and keep that olds 98 alive I have one and I love it old car but the best I have ever had I love mine and put a lot of money into it because it is worth every penny!!!! ;)
you take off the hair and pink nails of the car
What kind of bearings??Engine, wheel, trans,diff.?????
The front wheel bearings are sealed and are not greaseable.
auto or manual hubs
Yes. You should also replace the race at the same time.
Try going to "autoaccessories4less.com.
Same answer Go to DTAmotorsports and download you a free service manual. http://dta-motorsport.com
first thing to replace would be the flasher can
Get a manual from the parts store or AUTOBOOKSONLINE.COM.
you will have to drop your gas tank its inside the tank drive safe
Oldsmobile Silhouette was created in 1990.
The Oldsmobile Cutlass Ciera a was front wheel drive model. It was sold by General Motors from 1982 to 1996.
diagram of firing order on a 1990 Oldsmobile cutless 3.3 engine
where is the location of the horns on a 1990 Oldsmobile 98
You have to take off the rotors and calipers to get to the bearing then you probably need a heat gun to soften up the bolts to take them off
jack up van with wheel in question off the ground try to move it side to side it should not move also spin the wheel and listen for a grinding noise you may need a stethascope to do this step
The switch is on the steering column about 18 inches from the floor. Simply take 2 screws holding it on and replace it.The locck cylinder is under the steering wheel.
It was r-12. Thamk you because my 89 caddy Ac is kaput - probably has that also - and I will replace it with RS12A.
pull the wheel, remove the bearing dust cover, remove the cotter pin, remove the castle nut, slide the hub off, take out the rear seal and bearing, knock out the races reinstall in reverse order. pack bearings and hub with good grease don't go cheap. oh it helps to remove the brake caliper for a first timer
To replace the radio antenna on the 1990 Jetta you simply unscrew it (counter-clockwise) and screw the new one clock-wise. If you are replacing antenna with off the shelf product You will probably have to remove the wheel, wheel well fender protector, to have access to the bolt for the antenna
Front or Rear wheel drive?It varies according to the year and whether it is front wheel or rear wheel drive. Please expand your question. front wheel drive where is the starter for the cadillac fleetwood 1990
The 1990 Cadillac Sedan DeVille is front wheel drive. The 1990 Cadillac Sedan DeVille is front wheel drive. The 1990 Cadillac Sedan DeVille is front wheel drive.
check wheel bearings. check tires for cupping or feathering.
no it has dic brakes