Headlights Tail and Brake Lights
Chevy Silverado
Dodge Ram

How do you replace the right rear blinker-brake light bulb on a 1999 Dodge Ram 1500 pick up truck?

181920

Top Answer
User Avatar
Wiki User
2007-01-28 17:11:01
2007-01-28 17:11:01

There are 2 torex screws on the side that have to be removed. You have to open the tailgate to see these screws, once removed the taillight can be removed. It takes a bit of force however, there are also two pins that align it.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

locate the fuse box under dash and look for brake lights replace with the right amp fuse. the fuse you pull out will have a number on it that is the apms fuse you will need to replace

User Avatar

yes it is the same cab all parts will bolt right on

User Avatar

You have to replace the tail light as a whole unit. Open the tail gate. You will see two screws (star shape if I remember right) take these out. Then Pull the lens assembly out. Undo the bulb connectors byturning them quarter turn and pulling them out. There it is. Easy. Good luck.

User Avatar

you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light. you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light.

User Avatar

push the clip on the right side of the light behind the bumper, then the light just pops out

User Avatar

you open the trunk and pull back the liner you will see a few blots remove the blots and the light should come right out.

User Avatar

Right around $600.00. I just had mine done at the Dodge Dealer last month!!

User Avatar

More than likely you have a burnt out bulb at the front signal light, rear signal light, or brake light on the right side.

User Avatar

The right seal can be replaced by only removing the right shaft. To replace the left seal, the entire axle needs disassembled.

User Avatar

expose back of bulb, turn to the left, replace bulb, return to socket, turn to the right

User Avatar

You need to have it checked for codes. The light comes on when the engine computer detects a malfunction.

User Avatar

The license plate light and connected right above the plate on a 2002 Volkswagen Beetle. To replace it just unscrew the old light and mount the new bulb.

User Avatar

its orange and it is located on the right side of the gauge cluster

User Avatar

About an hour, but it can be dangerous without the right tools and knowledge.

User Avatar

Lower the tailgate and remove 2 screws. Grab taillight and pull firmly to the rear. Release tabs that hold bulb.

User Avatar

my left turn signal on my 1997 dodge conversion van works fine,the right signal lights but does not blink,,,,any ideas

User Avatar

How to replace right from headlight bulb on 2000 ford contour 4 cyl...?

User Avatar

open the trunk, and pull back the carpet and there will be 2 nuts holding the light in place. unscrew them and pull the light out.

User Avatar

If the Avalanche came with the factory trailering package, the trailer lights are separately fused from the other truck lights. Check your fuse panel layout for a 10-amp fuse for left side and a separate fuse for right side turn signal/brake light on the trailer.

User Avatar

on all dodge trucks the way you change the bulbs is simply unscerew the tail light assembly and remove it from the rear of the vehicle and you will see your lightbulb fittings right on the back of the light assembly

User Avatar

check the light bulb same double element bulb for both lights


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.