answersLogoWhite

0


Best Answer
Copy

First you start by putting a wrench on the nut that holds the free spooling pulley on the belt tensioner located towards the top of the motor on thefront. Pull the wrench counter clockwise so that the idler pulley ifts off the belt. With your other hand, move the belt and release the belt tensioner. You can now remove the belt being sure t tae note on how it came of as you have to put he new bel on the same way to ensure proper direction of the pulleys. If ou are one of the lucky ones, there is a decal on the top of te radiator support that shows a diagram of how the belt goes on. To installthe belt, just reverse the steps that you took to get it off.

User Avatar

Wiki User

โˆ™ 2015-07-16 18:13:53
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you replace the serpentine belt located on a 1989 Ford Bronco?
Write your answer...
Submit

Related Questions

Where can you find a serpentine belt diagram for a 1989 ford bronco 5.0?

Try the internet


Where is the horn located on a 1989 Ford Bronco?

It is located under the driver side headlight.


To replace a serpentine belt on a 1989 Oldsmobile cultlas cierra?

there is a diagram located on top of radiator also you can go to most any parts supplier and they will show you how.


Where is the heater thermostat located on a 1989 Ford Bronco 2?

The thermostat is located in the water neck where the top radiator hose goes on. Its mounted in an O-ring, just pop it out with a screwdriver and replace it.


Were is the fuel filter located at on a 1989 ford bronco?

On a full sized Bronco, it is located in front of the fuel pump between the frame rails near the drivers feet.


Where is the pcm located on a 1989 ford bronco?

The PCM for the 89 Bronco is located on the firewall on the driver side. You can access it from inside the cab, behind the parking brake pedal.


Where is the starter located on a 1989 Ford Bronco and how do you replace it?

its located where the tranny bolts up to the motor. disconnect the three wires from the starter, then take the three bolts out of the starter and pull it out. just remember where the wires go!!


Where is the jack located in a 1989 ford bronco xlt?

The jack should be located under the hood, on the passenger side.


Where is the inertia switch located on the 1989 Ford Bronco?

On the interior firewall to the left of the steering column


When changing the serpentine belt on a 1989 Thunderbird supercoupe how do you get past the radiator hose. Or how do you get off the serpentine belt?

you have to take that bottom radiator hose off to replace it


Diagram of a 1989 Bronco II Fuse Box?

list of fuses for 1989 bronco 2


How do you change the serpentine belt on a 1989 Cadillac Eldorado?

How Do I change the serpentine belt on a 1989 Cadillac Eldorado ?


How much does it cost replace an exhaust system on a 1989 Ford Bronco XLT?

$ 300 magnaflo sounds same as stock


Where is the thermostat located in a 1989 ford bronco xlt?

Follow the top radiator hose from the radiator , where it connects to the engine is where the engine thermostat is located


How do you replace the thermostat located on a 1989 Ford Bronco II XL?

Drain coolant. Remove upper radiator hose. unbolt 3 bolts on thermostat housing. take out old one. reverse to install.


How do you replace brake light on 1989 full size bronco?

Well you take out the tail light assem and remove the blown bulb


How to replace the serpentine belt in a 1989 Chevy Corsica?

there is a tensionor pulley that must be loosened using a 5/8 wrencth. wolverine


Where is the fuel reset button located on a 1989 ford bronco XLT?

look on the driver side firewall by the brake pedal


Where is the oil pump located on a 1989 ford bronco?

The oil pump is bolted to the bottom of the engine , inside the oil pan


Where is the act sensor located at on a 1989 ford bronco II?

emissionswhere is the air charge temp located for a 1987 ford crown Victoria 5.ol


How do you replace the head gasket located on a 1989 Mazda B2200 1.3L?

replace head gasket


1989 bronco 2 slop in the steering?

replace the steering gearbox.adjusting the old one will not take out the slope and will likely cause it to blow the seal .


Will the auto trans from 1986 302 bronco work in a 1989 351 bronco?

it shold


Will a 1984 ford bronco back window fit a 1989 ford bronco?

yes


What is the fuel pump wiring diagram for a 1989 ford bronco 11?

A wiring diagram of a 1989 Bronco 11 fuel pump can be purchased from most auto parts stores. It can also be found in do-it-yourself repair books for a 1989 Bronco 11.