answersLogoWhite

0


Best Answer
Copy

1. Using a 15 mm wrench place it on the pulley bolt of the tensioner pulley 2. Pull the pulley toward the front of the vehicle. 3. The belt will slacken then slide the belt to the side and remove 4. Replace the new belt starting at the bottom crankshaft pulley 5. Slide belt over each pulley in a counter-clockwise rotation excepting the idler pulley 6. After the belt is around all pulleys except the idler use the 15mm wrench to pull the tensioner pulley forward and slide the belt under the idler pulley and release slowly 7. The belt should go a. Under the crank pulley b. Up inside the water pump pulley c. Out around the outside of the air conditioner compressor pulley d. Under the idler pulley (this is the last pulley to put belt on) e. Across up and around the alternator pulley f. Down around the Power Steering pulley g. Up over the tensioner pulley h. Down under the crank pulley Good Luck and Safe Knuckles P.s. obscenities are optional i found a picture of the diagram fan belthes the web sit ( http://images.Google.ca/imgres?imgurl=http://www.2carpros.com/forum/automotive_pictures/30961_38000belt_1.jpg&imgrefurl=http://www.2carpros.com/forum/1994-plymouth-voyager-awd-van-belt-diagram-vt29503.html&usg=__tddNYKmPJbCrU07Ig13DTeL-ooQ=&h=298&w=450&sz=35&hl=en&start=17&um=1&tbnid=LUy7UhqTIcqsRM:&tbnh=84&tbnw=127&prev=/images%3Fq%3Dchysler%2B1998%2Bvan%2Bfan%2Bbelt%2Bpictures%2Bdiagrams%26hl%3Den%26client%3Dfirefox-a%26rls%3Dorg.mozilla:en-US:official%26sa%3DG%26um%3D1 )

User Avatar

Wiki User

โˆ™ 2009-04-15 21:26:10
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you replace the serpentine belt on a 1998 Chrysler Town and Country?
Write your answer...
Submit

Related Questions

How much should it cost to replace serpentine belt and tensioner on a 1998 Chrysler Town and Country?

I was told by a dealer $240 in January 2008.


How do you fix starter on a 1998 Chrysler Town and country?

Replace it.


How do you replace serpentine belt for 1998 Toyota Camry?

The 1998 Camry did not have a serpentine belt. Do you have a 1998 Corolla?


Does the 1998 town and country van have two belts in the engine?

The 1998 Chrysler Town and Country Van does not have two engine belts. The engine only has one serpentine belt.


How do you fix the serpentine in a 1998 V6 Camaro?

Replace it.


Where is the cabin air filter on a 1998 Chrysler Town and Country?

A 1998 Chrysler Town and Country does not have a cabin filter.


How do you change the timing belt on 1998 Chrysler town and country?

A 1998 Chrysler Town and Country would have a 3.8L V6. That engine has a timing chain not a belt.A 1998 Chrysler Town and Country would have a 3.8L V6. That engine has a timing chain not a belt.


What type of brake fluid should be used for a 1998 Chrysler town and country?

A 1998 Chrysler Town and Country uses DOT 3 brake fluid.


Where does the Wiper switch on a 1998 Chrysler Town and Country get power?

The wiper switch on a 1998 Chrysler Town and Country gets power from and is an input to the body computer.


Where does the spare tire go on a 1998 Chrysler town and country?

The spare tire on a 1998 Chrysler Town and Country is mounted under the very rear of the van.


Do you need to remove the serpentine belt to replace the thermostat in a 1998 dodge ram 1500?

no


How do you repair the serpentine belt on a 1998 Mitsubishi Galant?

You don't repair a serpentine belt. You replace the worn or broken belt with a new one.


Need copy of diagram to replace serpentine belt on 1998 Olds 88?

I found this information with a diagram of the serpentine belt. Hope it helps.


How do you replace the alternator on A 1998 town aND country?

Remove the belt from your 1998 Chrysler Town and Country alternator. Disconnect the wiring from the alternator. Loosen and remove the alternator retaining bolts. Reverse the process to put the new alternator on.


How do you remove the evaporator on a 1998 Chrysler town and country?

97 Chrysler town & country evaporator bolts location for removal


How do you replace kill switch on a 1998 Chrysler Concorde?

Chrysler vehicles do not have a kill switch.Chrysler vehicles do not have a kill switch.


Will a 1994 3.8 Chrysler Town and Country Transmission work in a 1998 3.8 Chrysler Town and Country?

No, all of the sensor plugs are different.


What is the spark plug gap for a 1998 Chrysler Town and Country?

.050 in.


How do you reset garage door opener on 1998 town and country?

on a 1998 Chrysler Town and Country how do you reset the On board garage door opener


How much does an auto shop charge to replace serpentine belt on 1998 Buick Skylark?

Maybe $100 tops....


Would the serpentine belt on the 1999 Chrysler Town and Country come off if driven through an large puddle of water?

Yes, it will come off if driven through an large puddle of water. It had happen to me with my 1998 T @ C.


Where is the fuel pump located in a 1998 Chrysler Town and Country?

It is in the fuel tank.


What ac freon type in 1998 Chrysler Town and Country?

R-134A


What tires are recommended for a 1998 Chrysler Town and Country?

215-65-16


Where is the starter on a 1998 Chrysler Town and Country?

Front of engine, near radiator.