Insert a ratchet or breaker bar in the belt tensioner and turn it slightly to release the pressure on the belt. Move the belt off the belt tensioner pulley and then release the belt tensioner. The belt should have plenty of slack in it now. Pay attention to the belt routing as you pull out the belt because the new one must go in the same routing. Make sure the belt is back in the proper route and then twist your belt tensioner and put the belt over the tensioner pulley. It should be tight again.
Ajustment bolt is located at the bottom of power steering pump.
paste this link and it will give you instructions to how to replace belt... http://www.wjjeeps.com/serpentine.htm How do I replace a serpentine belt on a 2001 Jeep Grand Cherokee? Give detailed directions on the belt remove and installation of a new belt.
they make a serpentine belt tool that you can get at just about any autoparts store to help you remove it.
Isn't it on the fan shroud?
Every 35-45k miles to be safe.
Loose or worn out serpentine belt.
The Jeep Grand Cherokee did not exist until 1993.
You have to tear the dash apart to get to the evaporator.
I'm trying to replace the headlight assembly for a 2000 Jeep Grand Cherokee Lerado. What bolts or screws do I remove
about every 60,000 miles. check it for cracks and stains. if its bad replace it.
Loosen bolt in tension pulley, then loosen tension bolt. Replace belt. Tighten tension bolt. Last, tighten bolt through pulley.
Yes they will.
Replace the caliper and bleed the whole system
Aproox 1/4 in side to side movement.
how to install a fuel pump on a 2000 jeep Cherokee 6 cylc
A 2000 Jeep Cherokee would have rear drum brakes.
How do I replace water pump on 2004 jeep grand Cherokee
There wasn't a 2003 Cherokee. The last Cherokee was 2000.