answersLogoWhite

0


Best Answer

should be able to get to them with an extension about 2 feet long with a wobbly on it.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the starter in a 1995 Grand Am SE 4-cylinder you can't reach the bolts should you be removing other parts to get to it Thanks?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the Starter on a 1995 Isuzu rodeo 4wd?

Hi, How Do You Replace a Starter on a 1995 Isuzu Rodeo, V6, 3.2 liter engine? Does anyone know where the starter is? Help. How Do You Replace a Starter on a 1995 Isuzu Rodeo, automatic, 4wd, V6, 3.2 liter engine? Does anyone know where the starter is? Thanks alot.


Where is the starter located on a 1995 Cadillac Eldorado?

I Bet You Have A Northstar Engine. Your Starter Is Under The Intake Manifold If So. To Replace This Is Nothing Short Of A Nightmare. If This Is What You Have Expect To Pay A Large Service Bill To Have It Replaced. Thanks General Motors


You need step by step directions on how to remove a starter on a 1990 Toyota corolla?

i also need step by step instructions on how to take off old starter and replace new one if any one knows this would be very helpful to me. thanks


Where is the starter located on 2004 Hyundai Santa Fe?

On a 2004 Hyundai Santa Fe, the starter is located on the top of the engine just to the right of the heat protector. To replace it, you have to remove the negative cable on the battery, and then remove the starter cables. Then remove the 2 bolts that hold the starter in place.


How do you replace the camshaft position sensor on a 2001 Daewoo Lanos?

I started by removing the camshaft cover, then I realized the many other parts have to be removed before being able to succesfuly replace the sensor.... I also would like to know the procedure. Thanks


1990 Sundance you are trying to replace a gear in the odometer Need instructions for removing needle from speedometer so you can get cluster apart Thanks Arnold?

It will be a special tool that you'll need. Check with O'riely or a dealer.


How do you replace the speakers on a 1988 Ford Ranger?

no thanks, mine are fine.........but thanks for offering!!


Replace drive belt tensioner 1997 Lexus ls 400?

i am trying to replace the belt tensioner on my 1997 ls400 , i got everything loose but there is a plastic seal right in front of it , it is holding the tensioner and there is where i got stuck , can someone tell me how to get the tensioner out without removing the plastic seal . thanks


Ford starter motor turns but doesn't engage engine and the flywheel and starter are fine what next?

thanks how many holding blots and where bad bendix (starter drive) if the spring in the starter bendix is weak or broken it will not engage the flywheel; but the starter will turn normally. bad thing is ,you have to pull the starter..good luck..


How often does timing belt need replaced on a 2004 4cylinder Kia?

My 2004 kia optima timing belt teeth fell apart at 93k miles. I would replace it at 80K. System: while your driving the car, the car would turn off while running. Don't try to turn it on to many times cause it can cause other problems. Get it tolled away. thanks


How do you replace the spark plugs on a 1999 ford expedition?

thanks


How do you replace the multifunction turn signal stalk on a 95 corvette Thanks.?

== ==