answersLogoWhite

0


Best Answer

remove battery cable then remove the 3 wires from back of the starter... 1 will just plug in (the very small 1 ).. one will be power and the other will be ground there are only 2 bolts in the starter 1 on top 1 on bottom the bottom will be a little hard to get to if u run in to trouble u can get me at vtecman903@aol.com good luck

User Avatar

Wiki User

โˆ™ 2015-07-16 18:23:54
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you replace the starter on a '99 Honda Accord 4 cylinder?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does the 2004 Honda accord 4-cylinder have many starter problems?

No, starter problems are rare on any Accord.


How do you unlock a 1988 Honda Accord starter that has seized up?

Replace the starter


How do you replace the radiator in a 2001 Honda Accord?

how toreplace radiator in a 2001 honda accord ex four cylinder


Step by step directions for replacing the starter on a 1994 Honda Accord?

Is there a good site to go to asap to find how to replace a starter for a 1994 Honda Accord EX


How do i replace a clutch master cylinder in a 1996 Honda civic?

how difficult is it to replace the MS on a 1996 Honda accord


Where is the starter located on a 2006 Honda accord?

where is starter relay on 2006 Honda Accord


Where is the location of the starter on a 2008 Honda accord?

for a 4 cylinder , its located under the intake manifold.


Where is Location of starter motor 2005 Honda Accord 4-cylinder?

Under the hood attached to the motor


Will a 1999 Honda Accord starter fit a 1998 Honda Accord?

yes


Where is the starter located on a 2004 Honda Accord?

where is the starter located on a honda accord with a v 6 2004 model


Where is the starter relay on a 93 Honda accord?

Don't think there exists one. The power go from the key cylinder directly to the solinoid on the starter.


How do i replace 2005 accord starter?

The starter on a 2005 Honda Accord is replaced by disconnecting the negative battery terminal, removing the starter shroud, and unbolting it from the block. The wiring harness is then disconnected and the replacement starter mounted.

People also asked