Toyota Tundra
Chevy Monte Carlo
Ford F-250

How do you replace the starter on a 1999 Monte Carlo?

242526

Top Answer
User Avatar
Wiki User
2014-10-07 02:13:34
2014-10-07 02:13:34

Replacing the starter on a 1999 Monte Carlo is fairly easy to do. The car will need to be jacked up to reach the starter. The wires will need to be disconnected from the starter before removing it. After the wires are removed, the starter can be taken down by removing the two bolts. After the starter is removed, replace it with a new one.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

How do i replace the purge valve on a 1999 Chevy Monte Carlo

User Avatar

video to learn how to replace the engine gasket..upper & lower gasket for 1999 Monte Carlo.

User Avatar

How do you pull the wheel bearing assembly out from hub far enough to squeeze new lug nuts into place? The car is a 1999 Monte Carlo Z34.

User Avatar

Water pump removal chevy monte carlo 3.8

User Avatar

If none of them work it is a bad Flasher Relay. Replace it.

User Avatar

Bolts on the caliper of a 1999 Monte Carlo will loosen to the left and tighten to the right.

User Avatar

where is the vaccum canister located on a 96 monte carlo

User Avatar

no. they will need to be out the same model of car. the software is different.

User Avatar

Yes, there is virtually no difference in the dimensions and installation hardware of body parts between 1995-1999 Chevy Monte Carlos.

User Avatar

How do you replace a starter in a 1999 suburban

User Avatar

I doubt it as they changed the body style in 2000.

User Avatar

The 1999 Monte Carlo cigarette lighter fuse can be found in the fuse box. The fuse box is located inside of the engine compartment.

User Avatar

how to replace the starter for a 1999 Hyundai elantra

User Avatar

i dont think it has one but check behind the glove box if there is one that is where it will be

User Avatar

The bolt pattern for the 1999 Chevrolet Monte Carlo is 5x115. This is the same pattern that is used on the Uplander and the Lumina.

User Avatar

The low side pressure port for the 1999 Monte Carlo should be on a pipe against the firewall. It is just to the left of the Dipstick.

User Avatar

The 1999 Chevy Monte Carlo does have an emergency fuel cutoff switch. The emergency fuel cutoff switch can be found in the fuse box.

User Avatar

it is below the throttle body follow hose

User Avatar

how do I set reset ignition security on a 1999 z34 monte carlo

User Avatar

on passenger side , on the side of the dash

User Avatar

Remove the wiring harness from the back of your 1999 Chevy Monte Carlo blower motor. Remove the blower motor retaining bolts. Remove the fan on the front of the blower motor. Reverse the process to install the new blower motor.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.