Headlights Tail and Brake Lights
Nissan Armada
Nissan Frontier

How do you replace the taillight bulb on a Nissan Frontier?

767778

Top Answer
User Avatar
Wiki User
Answered
2015-07-16 18:25:15
2015-07-16 18:25:15

There are two bolts that hold the tail lights in place. First, open your tailgate. If you have a bedliner, the two screws are behind it. If you have a bed extender, the bolts that secure the taillight are the same bolts that secure the brackets for the bed extender. Refer to your owners manual, page 8-35. Good luck.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


how can i replace a brakelight bulb on a 2002 nissan frontier?


Remove the taillight assembly to gain access to the bulbs


I believe you have to unscrew a couple bolts on the inside of the truck bed to get the taillight assembly off the truck then you can unscrew the light sockets and replace the burnt out bulb


how do you replace a taillight on a Honda 2002 Civic?


how to change a taillight in a 2008 Nissan maxima


Remove bedliner( if applicable). You must remove the taillight framing to get to bulbs. There are two screws located behind the taillight, that must be unscrewed to loosen the taillight frame from the truck body. Remove the two screws via the truckbed side and framing will loosen and bulbs can be replaced.



Take out the two screws and replace one or both of the lamps.


It cost me less than $3 if you talking about the bulb...not sure about the cover too



there are two screws or bolts that hold rear light assembly located on inside of bed (10mm wrench) remove these and the complete light assembly comes out. do not remember which light is taillight but which ever one isn't working is the one you replace. There are 3 bulb retainers in the rear light assembly. Turn whichever bulb retainer you need to replace counter clockwise and it will come out and bulb is then accessible. If you are having constant problems with this, you may have the same problem I had and there is a recall on taillight assembly and Nissan will replace it for free. just had mine done.


There are two bolts inside of bed unbolt to remove taillight. Remove bulb, push down slightly and turn. Replace with new and reassemble.


Lift up the hood and look at the back of the headlight you need to replace. Disconnect the electrical connection and then turn the bulb counterclockwise. Then pull it out and replace it with a new bulb. Don't forget to reconnect the electrical connection.


Taillight bulb replacment/Taillight housing replacement * Remove the rear inside trunk finishing panel to access the taillight housing mounting nuts * Free the grommet for the taillight electrical harness and the three taillight housing nuts then pull off the taillight housing * Rotate the bulb socket counterclockwise and pull it out of the taillight housing * To remove the bulb from the socket pull it straight out.To install a new bulb in the socket push it straight into the socket until it stops


* Remove the rear inside trunk finishing panel to access the taillight housing mounting nuts * Free the grommet for the taillight electrical harness and the three taillight housing nuts then pull off the taillight housing * Rotate the bulb socket counterclockwise and pull it out of the taillight housing * To remove the bulb from the socket pull it straight out.To install a new bulb in the socket push it straight into the socket until it stops


The 1998 Nissan Frontier is wired so one bulb indicates braking and parking light use. This is accomplished with a double-fliament bulb. The inherent advantage/flaw in this design is that one filament can blow while the other remains functional. This can be confusing when attempting to isolate and replace the defective bulb.


u un screw the light bulb and put in a new 1 god i mean how many retards does it take to change a light bulb


You can access the bulb from the trunk area (from behind). Just remove and replace, should be straightforward.


rear you use a torx driver to remove taillight assembly screws. them replace bulb.


The light bulb or the taillight lens? Open the trunk to replace the bulb.


* Remove the rear inside trunk finishing panel to access the taillight housing mounting nuts * Free the grommet for the taillight electrical harness and the three taillight housing nuts then pull off the taillight housing * Rotate the bulb socket counterclockwise and pull it out of the taillight housing * To remove the bulb from the socket pull it straight out.To install a new bulb in the socket push it straight into the socket until it stops


peel bak the carpet in the he rear of the light assembly unit, there are two clips to be moved and the unit pops out. replace the bulb and reassemble


Open rear hatch, there are two screws in taillight lens, take them out, the lens will lift out, turn the socket and it will relese, replace bulb, (I would recommend using some dielectric grease on bulb socket while you have it out), replace in reverse order. AJ


to change the bulb you go in from the backside, if its burned out you only need to replace the bulb. its similar to replacing a taillight bulb


Release the two tabs you can't find!



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.