Car Computers and Sensors
Peugeot 406
DIY Projects

How do you replace the temperature sensor?

222324

Top Answer
User Avatar
Wiki User
2011-09-13 14:00:54
2011-09-13 14:00:54

Make sure engine is cold. Unhook wire on sensor, then get a socket that will fit it and just unscreew it. Just be fast about it so you don't loose to much coolant and screew the new one back into the engine. Hook wire back up and your done.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Most engines have the temperature sensor either at the top water inlet or on the side of the block. Remove the sensor wiring, then unscrew the sensor to replace it.

User Avatar

Where is the transmission fluid temperature sensor on a 1998 Honda accord and how do you replace it?"

User Avatar

The coolant temperature sensor can be found on the front of the engine, near the thermostat. Remove the coolant temperature sensor retaining nut, to replace it.

User Avatar

Remove the tail gate then replace water temperature sensor.

User Avatar

Remove the wiring harness from the EGR temperature sensor. Remove the two retaining screws from the sensor. Reverse the process to install the new sensor.

User Avatar

were is the location of the ambient air temperature sensor for a 2001 bmw 330 i

User Avatar

The coolant temperature sensor, on a 2005 Ford escape, can be changed by loosening the sensor retaining nut. Once the knot is removed the sensor will pull out.

User Avatar

how to get to it on the car,how long does it take.

User Avatar

The sensor in question is located on the inside of the front bumper. If needed you can replace this sensor with relative ease.

User Avatar

coolant temperature sensor are located where the coolant runs in the block near the thermostat housing normally the connector are on top of the sensor and the sensor itself screws in with a deep socket. The temperature sensor is usaully located where the coolant runs OUT of the engine close to thermostat housing.

User Avatar

Losen the exhaust cross over and take off temp sensor

User Avatar

you can't fix a sensor, you can replace one by removing it and installing the new one...:)

User Avatar

If you do not know how to replace it, then you should not try to replace it. If you want to know WHERE it is, then look near the thermostat housing.

User Avatar

The 1991 Toyota Corolla cooling fan will stay on all the time if the temperature sensor is malfunctioning. Replace the temperature sensor.

User Avatar

1. Water temperature sensor Intake air temperature sensor cylinder head temperature sensor exhaus temperature sensor and catalytic sensor

User Avatar

It means it's time to replace the coolant temperature sensor.

User Avatar

Vehicle make, model & engine size needed first.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.