inside the radiator hose
follow the upper radiator hose other end is connected to thermostat housing
where is located the starter at 1990 Volkswagen jetta
To replace the 1990 VW Jetta water pump you need to have a new one. By using the tools in the tool box, carefully open the old water pump and replace it with a new one.
It is quite easy to change the thermostat in your 1990 Cutlass. Remove the thermostat housing retaining bolts. Remove the thermostat from the housing. Reverse the process to install the new thermostat.
The thermostat housing is located at the engine end of the lower radiator hose.
Follow the top radiator hose as it connects to the front of the engine. The thermostat is located in that housing.
1990 Camry 4 cylinder thermostat is located off the bottom intake hose connected to the engine block.
== == It's located within the thermostat housing, to the right side of the engine... follow the large rubber tube coming from the radiator and it shall lead you to the housing, which is held in place by two bolts. Warning: if you take the housing off, to replace the thermostat, be gentle with the thermoswitch, and it is also very fiddly to have the thermostat centralised on the housing when you bolt it back on.
it's located on the engine . or take it to the dealer . if you don't know what you are doing . those vehicle are expensive . if i were u . i take it to the dealer . Easy there! The thermostat is on top of the water pump and is a simple fix. You need an "O" gasket when you replace the thermostat.
Go to the library and get the manual; locate the appropriate instruction and follow it.
Follow the upper radiator hose towards the engine, you could see the water inlet housing , use a 10 mm socket to remove the housing . here is your thermostat. Don't forget to replace the gasget.
the engine is a v6
Follow the upper radiator hose down to the engine. It attaches to the thermostat housing. Usually, two bolts hold the housing onto the engine. More than likely, you will have to remove accessories-alternator-etc. to gain access to the bolts.
Follow the bottom radiator hose to where it meets the block.There is the thermostat housing
No great mystery here, pull the fuse out, if it is burned or blown replace it. If not put it back in.
If you follow the lower radiator hose to the engine block, it will lead you towards the thermostat housing (inside there is the thermostat),
follow the radaitor hose from the top right side it goes directly to the thermostat housing remove the bolt then there is your thermostat
The coolant fan switch is located close to the thermostat.
bottom radiator hose
follow the lower radiator hose to the engine. the hose attaches to the thermostat housing.
The thermostat is located on the front of the engine under the elbow at the end of the radiator hose
thermostat help fan come on when the car is runnning, keep the engine from over heating
The thermostat is located under the radiator cap. Take the cap off and there will be a little metal thing. Pull it out and there it is. The thermostat is located under the radiator cap. Pull the cap off and there will be a metal thing. Pull that out and there it is.
To replace the radio antenna on the 1990 Jetta you simply unscrew it (counter-clockwise) and screw the new one clock-wise. If you are replacing antenna with off the shelf product You will probably have to remove the wheel, wheel well fender protector, to have access to the bolt for the antenna