0
Remove the top radiator hose from the thermostat housing, its the round thing up front of the motor that the hose leads to it from the radiator. Then remove the bolts holding on to the top part of the housing, replace and reset all parts removed.
Add your answer:
Earn +20 pts
How do you replace a timing belt on a 1992 Acura Vigor 2.5L?
HOW TO REPLACE A TIMING BELT ON A 1992 ACURA VIGOR? how do you change a timing belt on a 1992 acura vigor 2.5l how do you change a timing belt on a 1992 acura vigor 2.5l -------------------------------- See article at the Acura Vigor Club -- Related Links (below).
How do you replace water pump on 1989 vigor?
there was no 1989 vigor..acura
What do you do if the key is stuck in your Acura Vigor switch?
Replace your ignition lock assembly.
How do you replace the wheel bering on a 92 Acura Vigor?
The front bearings on an Acura Vigor are pressed on bearings, unless you have access to a press or know of a shop that can do this for you I wouldn't attempt this job.
Where is the fuse for the fuel pump on a Acura Vigor?
The fuse for fuel pump on a Acura Vigor is located in the cabin fuse box. It is in slot 2 and is rated at 15 amps.
Where is your block heater cord on a 92 Acura Vigor?
The acura vigor does not have a block heater.
Where is an Acura Vigor PCV valve located?
It is located on the top of the valve cover towards the rear of the engine.
Where is the fuel pump on a 1992 Acura Vigor?
Where is the fuel pump locate on the 1992 acura vigor
Where is the ac relay located on a 94 Acura Vigor?
The ac relay on the 94 Acura is located under the hood. It is in the relay box mounted near the battery.
How do you remove 1992 Acura Vigor rear seat bottom?
The seats on a 1992 Acura Vigor use bracket which are found underneath and behind them. Loosen the bracket bolts to release the seats Pull them off and replace them.
Where is the fuel filter located on a 1992 Acura Vigor GS?
Fuel filter is located in the firewall-drivers side.
Where is the valet override button on an Acura Vigor?
You will need to unplug the connector on the hood switch. That is how you can override on an Acura Vigor.
