The thermostat can be located by following the top radiator hose to where it meets the engine. Drain the fluid first below at the radiator drain valve (remove the cap to speed the draining process, you won't need to drain very much.)
Remove the upper radiator hose at the engine, I believe it is a spring loaded locking clip.
Remove the hose. What the hose plugged into will be the thermostat housing. Remove the bolts carefully. Remove the cover and thermostat.
Clean all surfaces on both before reinstalling. Clean the bolts and use some never seize on them. Don't over tighten them.
Where is the thermostat
where do i find the thermostat for 99 cavalier
The thermostat is located in the thermostat housing at the engine end of the top radiator hose.
No, once a thermostat becomes so worn that it sticks, the best thing to do is simply replace it. A new thermostat is not that expensive, and the process is relatively simple.
What is the motor size? Run1
The 1994 Chevrolet Beretta thermostat is located on the front of the engine. You can follow the top radiator hose directly to the thermostat housing. The thermostat will be in the thermostat housing.
Follow the top radiator hose back to the engine. This is where the thermostat is. Remove the 2 bolts and there it is.
It is in the housing at the engine end of the upper rad hose. When replacing it make sure the spring on the thermostat is toward the engine.
how do you replace thermostat on 1994 Honda civic dx
The thermostat AND HOUSING will cost about $15 at O'reilly auto parts, and may cost a little more or less at other auto parts retailers.Note that the Saturn thermostat is cast into the thermostat housing, so it's a little different than other vehicles that you may have encountered.Labor to replace the thermostat may vary, depending on the shop and local rates.
Follow the upper radiator hose from the radiator to the engine and at the engine you will find a housing with the thermostat inside. When replacing it make sure the spring goes toward the engine.
The thermostat housing is located on the driver side between the distributor and the transmission. There are two 12mm bolts holding the the thermostat housing. You may want to disconnect the white colored sensor before removing the housing. The thermostat is located underneath the housing.