Follow the upper radiator hose from the radiator back to the engine. The part the hose attaches to on the engine is the thermostat housing. Drain a gallon of coolant or so and pop the hose off of the housing. The housing should be held on by two bolts. Remove any wires attached to sensors in the housing then the bolts. When the housing comes off the thermostat will be directly underneath. Always replace the thermostat gasket if there is one. If the hose is held on by the factory clamp I always replace them with a stainless steel worm clamp because they are so much easier to use. JPS.
The thermostat on a 1991 Buick Skylark is located near the engine. To find the thermostat, follow the top radiator hose directly to the thermostat.
How do you replace the water pump and where is it located on a 1996 Buick Skylark V6
I have a 93 buick skylark and i cant find the thermostat on the da*n thing.. can anyone explain to me on how to change it??? Follow the hose to the top of the engine where it ends. The thermostat is under the thing where the hose is attached. There are two bolts holding it down. Also, get a Chilton's or Haynes manual from Amazon. They have the procedure and the books are cheap.
From a small pipe connected from the top of the engine to a radiator hose.
how do you replace the alternator in a 97buick skylark
If your car is over heating you may want to check your thermostat and replace it may solve your over heating problems
inside the radiator hose
Where is the transmission solenoid located on a 1995 buick skylark custom?
you replace it by...hold on
how do you replace a ignitionswitch tumbler 1991 buick skylark
The temperature sensor to the computer is located on the thermostat housing. On the 4 cylinder it is on the right side of the engine block.
The hose that goes in the top of the engine, the thermostat is in the hose.Unscrew the hose take the thermostat out and replace,Very easy