You need to pull the upper radiator hose from the engine (not from the radiator). The little round bugger w/ a spring on it in the hole from the radiator connection should be your thermostat. Pull it, drop in a new one, and then re-attacth the hose to your engine. You may have to pull the plastic "3800" molding off your motor to expose where the hose connects to the motor. Just a warning, the hose is a bit stubborn about getting back on...
To replace the thermostat on a 1988 535i, first locate the top radiator hose and remove the end connected to the motor. Take out the old thermostat and use gasket cleaner to remove the old gasket. Then replace the gasket and thermostat exactly as it was when it came out. Tighten up the radiator hose over the thermostat.
Remove the water supply hose from your 1988 Chevy Cavalier thermostat housing. Remove the thermostat housing bolts. Lift the old thermostat out and drop in the new thermostat.
Drain the water from your 1988 Chevy Corvette cooling system. Remove the water supply hose from the top of your thermostat housing. Remove the thermostat housing bolts. Remove the thermostat. Reverse the process to install the new thermostat.
its an forgine peice of junk
take it out and put a new one in!
Is it easy to replace the thermostat on my Ford 1988 F-350 Diesel truck? My engine overheats when on long drives or steep grades. HELP ASAP. Bradley
thermostat is located on engine block. follow top water hose leading to engine. thermostat is located inside the water intake. remove hose. remove water intake(two bolts)housing. replace thermostat. .
how do you change a thermostat on a olds cutlass supreme 1983
More then likely you need to replace the Thermostat.
The thermostat is on the top of the motor where the top radiator hose attaches to it. The housing for it should be held on with two bolts. Remove the bolts and lift up the cover. There's the thermostat.
Palais Royale - 1988 is rated/received certificates of: Australia:M Iceland:12 UK:15 West Germany:16
You can locate the thermostat on the front of the engine follow the upper radiator hose back to the engine - the thermostat is located in the engine housing that the hose connects to, there are usually 2 bolts that you need to remove, take of the housing that holds it in place, remove the gasket and clean, test the thermostat or put in a new one - to test the thermostat hold it over a boiling pot of water with tongs if the thermostat opens this is not your problem if it does not open then your thermostat is faulty. Replace and reseat thermostat, replace the gasket, replace the bolts and radiator hose.
If the pump is in the tank which i believe most are you would have to drop the tank out. there would be no way around it.
about 25/30 min depinding on your skill
Delta Regina Hotel was created in 1988.
The noise is possibly the electric fuel pump that is located inside the fuel tank. The tank is located under the vehicle below the rear seat.
I have a 1988 4door It is located on drivers side just in front of rear wheel on the frame rail. Hint!! After i found it, I sprayed with wd-40 for a few days to help with removal.
i would like a diagram and instructions on how to change inner tierods for a delta 88 1988
Good Old Boy A Delta Boyhood - 1988 is rated/received certificates of: USA:PG
Its right there in the front its two bolts i believe look right pest your radiator cap it has a rounded housing and its silver looking
At the engine end of the top radaitor hose, under the thermostat housing.
How do you replace the alternator on a 1988 Pontiac Fiero
Gamma Phi Delta Fraternity was created on 1988-03-21.
Anyway, it is located in the lowerr radiator house, at the engine, when the engine is cold drain the coolant, remove the lower hose, pop out the thermostat, remove gasket, clean surface and replace. Fill with coolant, let it get warm, then add more coolant when the new thermotat opens up.