Should be located in a removable housing at the engine end of the upper radiator hose Drain about 1 gallon of coolant from the radiator
Remove this housing
Make note how thermostat is installed
Clean both surfaces
Replace thermostat and gasket
Re-fill coolant slowly to prevent an air lock
Start engine and look for leaks
Run engine to normal operating temperature with heater on
Re-check coolant level
how do remove the brake drum on a 1991 mazda 323
You can find the 1991 Mazda 323 fuse box diagram at your local Mazda dealership. You can also find the fuse box diagram on the inside cover of the fuse box.
replace headlight on mazda sp20
Look at the engine end of the upper radiator hose in a removable housing
The 1991 Mazda 323 came equipped in two OEM tire sizes. Assuming the vehicle still has the original wheels the sizes were 155-13 and 175/70/13.
My 1991 Mazda 323 has two plastic screws on drivers side, facing engine. Are they airbleeder valves?
Go to a mechanic :)
IF ITS A 1.8, THEN ITS NEXT TO THE TIMING COVER
It is at the lower end of the top radiator hose within the water outlet on the motor.
ollie Collins2 horns behind the front bumper
== == It's located within the thermostat housing, to the right side of the engine... follow the large rubber tube coming from the radiator and it shall lead you to the housing, which is held in place by two bolts. Warning: if you take the housing off, to replace the thermostat, be gentle with the thermoswitch, and it is also very fiddly to have the thermostat centralised on the housing when you bolt it back on.
No sorry they are completely different.
Mazda 323 familia valve timing set up
That would all depend on what model you are refering too. 1991 and 1992 Mazda 323 parts are all interchangable (there may be a few exceptions). If your refering to another model, someone else will have to address that aspect.
114x4 thats what i was told on my mazda 323 '84
Between 6 - 8 degrees BTDC
If your Mazda 323 is a 1994 then it could well be your thermostat. I had an over heating problem when my 323's temp gauge was flying off the rails. I tried lots of things even took it to 7 mechanics and they all said my headgasket had blown. I found the thermostat after it being so old it starts to jam up. I replaced it and walah. Main symptoms are your radiator water beginning to boil and shake you can hear it too. If you find the pipe connected to your engine on the right hand side of your radiator take a set of pliers and undo the jubilee clip on the engine side of the pipe. Take of the inlet which is holding the pipe to the engine by 3 bolts. The thermostat is located behind it. Replace the thermostat which you can pick up for around £6 then replace everything, refill your radiator and bobs your uncle. good luck
The speaker size for a 1992 Mazda 323 would be 6-1/2.
Unfortunately, it's inside the timing cover :-) My tip is to replace the timing belt at the same time. not a nice quick job either I'm afraid.
Replace the thermostat and have the radiator flushed and refill with new coolant. These cars which are also ford lasers have always been pieces of junk in my view because just about everyone i see is bellowing out oil smoke. Get rid of it
In the gas tank. There's an access hatch located under the rear seat.
The sensor is threaded into the head to the left of the thermostat housing and has a single wire connector on it. Thanks Malcolm