VW New Beetle
Turn Signals and Hazard Lights
DIY Projects

How do you replace the turn front signal assembly on a 72 bug?

151617

Top Answer
User Avatar
Wiki User
2005-09-22 18:44:13
2005-09-22 18:44:13

First unscrew the turn signal lense. Next, unscrew the metal panel from the fender. Under the fender there will be three wires, unplug all of them. Put the new metal panel on a hook up the three wires, making sure that you hook up each color correctly. Next make sure that there are bulbs in it. Finally screw on the turn signal lense. Then you can test the turn signal to make sure it works. If it doesn't, then look at the wiring under the fender to see if it is hooked up right and then look at the bulbs to make sure they work.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Open the hood. Near the front of the turn signal assembly there is a Phillips head screw. Loosen but do not remove the screw; it releases the front of the assembly. You then need to pull forward to release the pin holding the rear of the assembly. Reverse the above to replace the assembly.

User Avatar

If you remove the headlight assembly you will have access to the turn signal bulb.

User Avatar

you must completely remove the complete front headlight assembly

User Avatar

Reach behind the bumper of the 99 Cavalier. There are two nuts that hold the turn signal assembly in. Remove the nuts to take the assembly off and replace it.

User Avatar

The front turn signal assembly will pop out with a little help. It is held in place by clips that snap it into place.

User Avatar

It looks as if I'll have to crawl under the front of the car to access the bulb to replace it.

User Avatar

To replace the turn signal switch of a 1996 Dodge Caravan, open the engine's hood to access the front turn signal bulbs. Then take the headlight assembly a little off the front to give room to get the bulbs. Remove the old turn signal switch and slip the new one in place.

User Avatar

How do you replace a front turn signal bulb for a 2000 sts cadillac?"

User Avatar

Just had to do this. At the top outside edge of the headlight assembly, where it meets the turn signal assembly, there is a space you can put a finger through and push down a plastic tab. It's not hard to see if you know it is there. With the tab pushed down, the whole turn signal assembly can be pulled forward and out.

User Avatar

Begin by removing the wiring harness from your 1983 Volvo 240 turn signal lamp. Remove the turn signal lamp assembly retaining bolts. The turn signal lamp assembly will come out. Reverse the process to install the new turn signal lamp assembly.

User Avatar

Unplug the whole light assembly from the bottom front of the car it just pops out to replace the turn signal bulb-same on the rear but you have to remove the trunk lining first.

User Avatar

If you are talking about a front turn signal, there is a release tab inside the fender. when you push it it will release the whole light assembly. Then you can access the bulb

User Avatar

How do you replace the front turn signal bulb located on a 2001 Buick Century?"

User Avatar

trouble putting right front signal bulb in.

User Avatar

Turn signal lever assembly can be replaced without removing the steering wheel. See instructions at the attached link question about replacing the headlight switch on a 1999 Subaru Forester.

User Avatar

you have to remove the whole headlamp assembly to get to the turn signal bulb pull the headlight assembly straight out it is fairly easy There are two wing nuts on top of the unit that must be removed.

User Avatar

HOW TO REPLACE FRONT TURN SIGNAL BULB 2007 EQUINOX

User Avatar

rear you use a torx driver to remove taillight assembly screws. them replace bulb.

User Avatar

i need to replace a throttle sensor and put a throttle body rebuild kit in

User Avatar

This is the turn signal bulb in the front bumper - passenger's side.

User Avatar

Look back on responses to how to change headlight or turn signal assemblies on this page. Do the same thing, just twist out the bulb and twist in the new and reassembe. You must remove the turn signal assembly and the headlight assembly must be loosened. But it is very easy.

User Avatar

One or two front turn signal bulbs is busted. Check your front turn signal bulbs and replace it.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.