Buick LeSabre
Turn Signals and Hazard Lights

How do you replace the turn signal switch located on a 1993 Buick LeSabre?


Top Answer
User Avatar
Wiki User
2015-07-16 18:14:33
2015-07-16 18:14:33

If all that broke is the metal shaft inside the lever, you can replace the complete lever with the multi-function controls quite easily. To revemove the complete lever assembly, open the small coverplate on the steering column behind the wheel, (towards the dash). This small coverplate comes off easy. Under this cover you will see the cruise control wires, (if you have cruise control). Disconnect these wires at the wire harness. To remove the lever assembly, just pull out, away from the column. There is a small detent in the metal shaft that holds it in, just pull firmly and it will come out. You can buy a replacement from the dealer or a junkyard. Reverse the procedure and you have a new lever installed.


Related Questions

User Avatar

It is quite simple to replace the turn signal switch on your 1990 Buick LeSabre. The turn signal switch simply plugs in and out.

User Avatar

There is a very good step-by-step at this site:

User Avatar

replace the combination switch on the turn signal stalk

User Avatar

To replace the turn signal switch on a new Beetle, the old switch has to be removed and a new one plugged in. The turn signal switch or flasher is located under the dash just above the brake pedal.

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.