answersLogoWhite
Mitsubishi Mirage
Turn Signals and Hazard Lights
Chevy Camaro RS

How do you replace the turn signal switch located on a 1998 Mitsubishi Mirage DE?

505152

Top Answer
User Avatar
Wiki User
2006-10-22 20:58:34
2006-10-22 20:58:34

Replacing the turn signal switch involves replacing the entire turn signal assembly. Remove the screws from the steering column cover to remove the top of the steering column. You can take off the bottom (I was able to work around it). There are only a few screws holding the turn signal assembly. Remove the screws and unfasten the electrical connectors.

1

Related Questions

User Avatar

The 2001 Mitsubishi signal flasher relay switch is located beneath the drivers side dashboard. The signal flasher relay switch will be above the accelerator pedal.

User Avatar

Governor is internal, part of your ECU. The signal for it is your speedometer.

User Avatar

In order to fix a Mitsubishi mirage signal light that doesn't turn off, you would need to understand the wiring system. This is a problem with the wiring and the circuit that connects the power from the battery to the signal light.

User Avatar

The turn signal switch is mounted in the steering column. Unscrew all 5 screws in the bottom of the lower cover and remove the lower and upper covers. You should now be able to see the switch itself and how it is mounted to swap it out.

User Avatar

Front seating area, driver side, under dash, below steering column, mounted in relay block.

User Avatar

The turn signal flasher on a 1998 Mirage is on the driver's side under the dash. It should be above and just to the left of the brake pedal.

User Avatar

White wire coming from the distributor.... remove a section of sleeve from wire and splice the signal wire from tachometer to it!

User Avatar

How do you replace the front turn signal bulb located on a 2001 Buick Century?"

User Avatar

The turn signal unit is located underneath the instrument panel to the right of the steering column.

User Avatar

buddy: this kind of cars/engine use a cam shaft sensor and crank shaft sensor that mean the computer send the signal for the spark. and don't use an rotor/ cap, coil and you can not fix the timing. i hope this help.

User Avatar

What kind of car 1999 mercury mountaineer

User Avatar

If you remove the headlight assembly you will have access to the turn signal bulb.

User Avatar

The 2003 Mitsubishi turn signal fuse can be found in the fuse box. The turn signal fuse will be in the second column, fourth from the top.

User Avatar

Hello - I have a 1987 Montero/Raider. The turnsignal/hazard relay is on the drivers side underneath the dash. It simply unplugs/plugs in. It's not hard to get to. Use a flashlight. Mine was very inexpensive to replace.

User Avatar

hard to find the tach signal wire due to the fact that the ignition coils are built into the distributor (old cars always easy to work on) to get the right wire l have posted a page on how to install a tach to your Mitsubishi. go to www.sureyya.biz and click on Mitsubishi tacho install. Dont forget to give feedback on how useful the info was.

User Avatar

HOW DO YOU GET THE LEFT TURN SIGNAL BULB OUT ON A 2000 PONTAIC FIREBIRD

User Avatar

It's the turn signal indicator-located behind the hazard lights.You have to take it out and replace it.

User Avatar

Turn signal flasher is part of the hazard warning module and replaced as a unit

User Avatar

To replace the turn signal switch on a new Beetle, the old switch has to be removed and a new one plugged in. The turn signal switch or flasher is located under the dash just above the brake pedal.

User Avatar

Front signal bulbs on a RSX are changed from the engine bay. Find the lightbulbs for the signal bulbs located towards the bumper of the vehicle. Pull them out and replace them.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.