first you need to remove the 3 phillip screws on the steering cover trim then remove the small bolster under the odometer.there are 2 torx screws#15 to remove the switch assembly.disconnect the wiring and reinstall in reverse.good luck!
disassemble steering column,and replace signal arm ass'y
short in your turn signal switch...replace it.....check your brake lights
In most cases you will need to replace the turn signal switch on the steering wheel for your 1983 Chevy Caprice Classic rather than fixing it. To replace it, remove the horn pad and then use a steering wheel puller and compressor to remove the steering column. You will then remove the signal along with the wiring harness and bus fuses. Replace the signal and wiring and then replace the steering column itself.
My turn signal switch died on my 92 Grand Prix. Rather than attempting the repair, I took it to a shop. The steering column had to be removed to get to the switch.
remove the steering column shouds and use a T20 torx screwdriver to take the two T/S switch mounting screws out and replace the switch.
To replace a turn signal switch on a 2003 Pontiac Aztek, also known as a flash relay, the steering column must be removed. The flash relay is located under the turn signal. Remove the mounting hardware and the unit can be taken off.
You will have to pull the steering wheel off to get to the switch, after the wheel is off take top cover off steering column and you will see how the switch bolts in.
The turn signal switch is on the left side of the steering column.
The turn signal switch is quite easy to remove and replace. The turn signal switch simply plugs in and plugs out.
What car
You have to take apart the steering column, remove the steering wheel, remove the ignition switch, and it's a pain in the butt.
The turn signal switch is directly under the steering wheel. the flasher...(the device that makes the lights blink and is activated by the turn signal switch) is usually under the steering column between the column and pannel