Voltage regulator is located behind the battery in the inner left (driver's side) panel, in the front part. You must remove the battery in order to reach the regulator. Use a quality replacement part or your eec computer may go toast. Voltage should read aprox. 12V with engine off, and about 15V with engine running. Good luck fella.
Most Ford alternators have an integrated regulator... it's inside the alternator.
what is the cost to replace the rack and pinion on a 1994 mercury sable
Inside the alternator.
1999 mercury sable horn replacement
You will have to drop the fuel tank and get the part (9b190) from ford. It is labeled on how to remove it. I am in the process of doing this myself.
Replace auto lamp module.
Mercury Sable was created in 1986.
No, you do not.
You must remove the fuel tank in order to replace the fuel pump.
13.8 - 14.4 volts DC,13.82 with engine running and headlights on!
Its round it has one line coming in one going out.
To replace the 1996 V6 Mercury Sable climate control and take out the old control, you will need to remove the covering below the steering wheel and dashboard. Then, access the climate control in the instrument panel and remove the old control.
Its a whole led unit replace whole deal not bulb
what its the paint code for 2002 mercury sable
how do I remove my air bag from my mercury sable
where is the solenoid on a 2004 mercury sable
Trouble code P1633 means: Keep Alive Power Voltage Too Low
No, the 1994 Mercury Sable does not use R12 for recharging the A/C unit. The 1994 Mercury Sable uses R134a Freon.
anywhere between $500 and $750.
This is same procedure as detailed in the "Related Question" below.
Replace your transmission pump or get a new transmission.
did you replace the master cylinder if so it has to be bleed frist