Caution:On models with a Delco Loc 2 or Theftlock audio system be sure the lockout feature is turned off before proceeding * Disconnect the negative battery cable * Drain the cooling system * Remove the cooling fan then remove the serpentine drivebelt 2.2L OHV Engine * Remove the water pump pulley from the front of the water pump * Remove the coolant reservoir hoses * Detach the water pump retaining bolts and remove the pump from the vehicle 2.3L And 2.4L OHC Engines * Disconnect the oxygen sensor harness connector * Raise the vehicle and support it securely on jackstands * Remove the exhaust manifold brace and loosen the exhaust manifold bolts * Remove the radiator outlet pipe assembly to the water pump housing bolts and separate the assembly from the engine * Remove the exhaust manifold pipe from the exhaust manifold * Remove the radiator outlet pipe from the oil pan.On manual transaxles cars remove the exhaust manifold brace and keep the radiator inlet hose attached to the assembly.Pull down on the radiator outlet pipe in order to disengage the pipe from the water pump while leaving the radiator outlet pipe hanging * Lower the car remove the brake booster vacuum hose from the camshaft housing also remove the exhaust manifold from the cylinder head * Remove the timing chain cover from the engine * Remove the timing chain tensioner * Remove the water pump cover bolts from the engine block and the timing chain housing * Remove the water pump bolts and separate the assembly from the housing
The price varies depending on where you purchase the water pump but the average price for a 1995 Dodge Avenger is around $24.
get a service manuel ..... the water pump is behind and run by the timing belt .... if you are not experianced at setting up the timing marks on a DOHC motor get help or take it to someone who is .........
you have to remove the oil pan and replace the pump
1.25 hours
12 hours before you add the coolant and 24 before you drive
Yes it does have a voltage regulator. It is incorporated into the alternator assembly.
It is inside the front of the engine, driven by the timing belt.
Long enough to turn over the full amount of water in the pool every 24 hours.
18 ft lbs, 24 NM
It depends. You can turn the pump off for an hour or two unless you have a huge amount of fish for the size of your pond. The pump gives them oxygen. It is important to have the pump working 24 hours a day - consistently. This makes certain the lake water is being circulated and sent through a channel. It is exceptionally basic to channel the complete measure of water in your lake consistently. By accomplishing this, it is the perfect approach to ensure to have clear and solid water.
water pump .(gasket,intake,hose)
You could use your pool pump. or get a submersible pump. it is also not difficult to siphon an above ground pool with a pool vacuum hose. all you need is somewhere to run the water to.