its behind the timing belt. first remove the p/s pump and bracket, then the alt. belt. remove the upper and lower timing belt covers. make sure to align crank to top dead center. remove timing belt and you should be able to remove the water pump at that point. use a factory Honda/Acura water pump. the aftermarket parts ate garbage. make sure not to mess up the timing when reinstalling the t-belt and adjuster assy.
location of fuel relay on 1987 acura integra
You can fit a 1.8 liter engine into your 1987 Acura Integra. You will need to modify the engine mounts and the wiring harness.
Well the 1987 Honda crx si ECU is interchangable with the 1987 Integra ECU, plugs rite up
At the power steering reservoir.
if it standar mabe is the clutch cylinder is broken
Inside the dashboard panel on the drivers side.Type your answer here...
im loking for gas filter im loking for gas filter
There is some stuff on ; www.carbasics.co.uk that should help you to identify it and locate it.
no. different motor series. but the motor and transmission is
The main fuel pump relay is behind the fuse panel on the drivers side. It has a connector which will need to be unpluged and a screw holding it to a bracket. The new one will go in place of the old one.
The majority of Honda/Acura Inline 4 cylinder engines correct direction of rotation is COUNTER-CLOCKWISE. Only some of the newer 4 cylinders are clockwise as with most of their V6 engines. I owned a 1987 Integra, so I know this for sure.
the browntop will fit in any Honda crx del sol civic teggy accord prelude all just need the mounts
Hello, I have a 1990 acura integra and we found a lot of info on line from the library, but to do it on line you need a library card. or you can go to the library and you can use there computer to look it up, we were even able to find the wiring diagram for her. and they will even print out the pages you may need. I hope that helps. Good Luck
it depends on what the climate you may use a 10w30 in hotter weather and 5w30 in colder weather, or if you run your car heavily use a thinner weight of oil
How do you replace the water pump on a 1988 Cadillac Seville?
It will cost approximately $350 to replace your 1987 Acura Legend heater core. The heater core will cost approximately $50. It will take approximately 5 hours of labor to complete the job.
The radiator support on all hondas/acuras are all tack welded in. you will see like a small indentation of a circle at every tack weld.
how to replace water pump celica 1987
If I understand the question correctly, you're wondering what cars the '87 Integra engine will fit in. The only car I know for a fact that it will fit with modifications to wiring and ECU would be the Honda CRX, I'm unsure of the years but it shouldn't be too hard to find. If you're wondering what engines will fit in the '87 Integra, there aren't many alternatives. There's the '88-'89 Integra engines, those have an extra 5 horses over the '86-'87 engines but you will have to redo wiring and get a new ECU. A better choice would be the JDM Browntop Integra ZC. A direct swap with no modification required and has around 30 more horses than the stock engine.
Most of the time it is a lot cheeper to repair then replace. It could be as simple as a bad set of brushes or a bad diod. But repairing it is always cheeper then a replacement. Look in the yellow pages under alternator repair and rebuilding.Take it to them and thy can repair it.
the starter is located just above the transmission but who ever is asking this question should deffently take there car to a professional just stop what your doing and at least ask a friend to help
In the manual transmission there are two big bolts, one on the top, one on the bottom. Remove both to drain it. Put the bottom one back in and fill her up. I'm unsure of where it is on the Automatic transmission.
Drain the water from your 1987 Nissan Stanza. Remove the water return hose from the water pump. Remove the water pump retaining bolts. Reverse the process to install the new water pump.