answersLogoWhite
Water Pumps
Dodge Durango
Nissan Pathfinder
Toyota Cressida

How do you replace the water pump on a 1990 Toyota Cressida?

104105106

Top Answer
User Avatar
Wiki User
2005-10-30 06:32:44
2005-10-30 06:32:44

There is no special procedure for replacing the water pump. You will have to remove the belts, fan at a minimum. To make the job easier it is recommended that you remove the radiator. It is also wise to service all consumable parts at that time with genuine Toyota parts: Hoses, coolant, thermostat & belts.

1

Related Questions

User Avatar

how the sequence of spark plugs goes on the engine of 1990 Toyota cressida

User Avatar

Are you sure of the engine size? Should be 7mge inline six cyl. 22r wasn't offered in a 1990 cressida.

User Avatar

Pls let me know the cylinder head bolt tightening sequence for toyota cressida mx83

User Avatar

how do i replace a power steering pump in a 1990 toyota camry?

User Avatar

Its under the intake manifold/plenum towards the rear of the engine

User Avatar

Where is the Water Pump located and how do you replace it on a 1990 Chevy Corsica?

User Avatar

How do you replace a waterpump on a 1990 BMW 325i

User Avatar

Buy a kit at Wal-Mart or auto parts comes with instructions Probably will have to be converted from R-12 to R-134

User Avatar

depends on what motor is in both of them are they both 4cyle or 6cyle

User Avatar

yes but do check first because a 1990 Geo prizm is basically a re branded version of a 1990 Toyota corolla.

User Avatar

To replace the 1990 VW Jetta water pump you need to have a new one. By using the tools in the tool box, carefully open the old water pump and replace it with a new one.

User Avatar

Replace the head gasket is the only fix.

User Avatar

how do I replace the seal on a 1990 Toyota 4x4 pick up, where the transfer case meets the exterior housing of the manual transmission?

User Avatar

I had the same problem with my 1989 Toyota cressida and when I had it looked at they said it was because the temperature gauge kept getting stuck and when it got loose it would fly way up into the red line and then return to normal like yours, you should get it replaced so that your car would send out unnerssisary engeint coolent

User Avatar

A 1991 Toyota 4runner is bigger than a 1990 4runner

User Avatar

how do I remove the water pump from my 1990 Isuzu truck?

User Avatar

you have to unhook the whole filter that looks like a canister then replace it using the new copper gaskets.

User Avatar

about 300 bucks, unless you know a mechanic because the part itself is pretty cheap around 20$ its just the labor that is expensive!

User Avatar

Separation of the ethanol due to water in the gasoline.

User Avatar

how to reset oil timing on 1990 toyota

User Avatar

My Chilton Says 1990 -92 Idle IN Park At Operating Temp Should Be 750, in drive 700, i cant ever seem to make the rpm drop only 50rpms when putting in park, so mine is set to 800, and about 700 in drive


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.