Water Pumps
Windshields and Wipers
Nissan Pathfinder
Dodge Dynasty

How do you replace the water pump on a 1991 Dodge Dynasty 3.0L?

383940

Top Answer
User Avatar
Wiki User
2004-11-27 11:22:32
2004-11-27 11:22:32

The question you ask is too involved for a proper answer. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do i change a water pump in a 1991 dodge shadow with a 2.2 liter does it require an internal water pump

User Avatar

The PCV valve on a 1991 Dodge Dynasty 3.0 engine is on the passenger side of the vehicle. It is on the crankcase.

User Avatar

a diagram for a 1991 dodge dynasty w a 6 cylinder 3point 3 liter engine

User Avatar

what is a controller in 2.5 motor in a dodge

User Avatar

The 1991 Dodge Dynasty starter relay switch can be found in the fuse box. The starter relay switch will be in the third column, third from the top.

User Avatar

What you need to do is open the trunk. Then you need to remove the liner in the back of the trunk closest to you then you can see the wires the twist out.

User Avatar

The fuel pump is located in the fuel tank, meaning you'll have to drop the tank in order to replace the pump.

User Avatar

A 1991 dodge dynasty speedometer bouncing could be a sticking speedometer cable, or a bad drive gear. Check the cable first, and lubricate it to see if the problem stops.

User Avatar

The engine computer is behind the battery.

User Avatar

Your fuel pump will be inside the gas tank.

User Avatar

It threads into the exhaust manifold on the back of the engine.

User Avatar

AnswerIt is in your fuel tank. The tank has to be dropped to replace it. How to replace the fuel filter in the 1991 Dodge Spirit?Oh by!!!!, good luck

User Avatar

how to replace a water pump on a 1991 acura legend

User Avatar

There isn't a water control valve. The airflow is directed around the heater core by a door to control temp.

User Avatar

Dodge doesn't use fuel switches. The fuel system is computer controlled with relays.

User Avatar

Bring to a shop that has an ABS Scanner

User Avatar

Please see "related questions" link at lower left.

User Avatar

5w 30 or 10w 30 will work just fine

User Avatar

The voltage regulator is located in the Single Board Engine Controller (SBEC or ECM). If you have to replace it, you have to replace the computer. The computer has the voltage regulator in it. The alternator gets feedback from the computer to produce more of less voltage.

User Avatar

all idle speeds arfe controlled by the computer and are not adjustable.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.