Best Answer

It is a pretty good job. Get a manual fron the parts store.

User Avatar

Wiki User

โˆ™ 2015-07-15 19:28:17
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you replace the water pump on a 1992 Mitsubishi Galant 3.0L?
Write your answer...
Still have questions?
magnify glass
Related questions

Where is throttle position sensor on 1992 Mitsubishi Galant?

on the front side of the throttle body.

Where can you locate the timing chain stats for a 1992 Mitsubishi Galant?

You need a shop manual on it. Get one at a parts store or MOTORLIT.COM.

How can get a wiring diagram for 1992 Mitsubishi Galant from the distributor to the ignition coil?

Chilton's repair manual (about $20.00) has all the wiring diagrams for your entire car.

How do you fix a head gasket on a Mitsubishi pajero gls 1992?

Replace it which is a major repair.

How do you replace a water pump in 1992?

how do you install a water pump on a 1992 toyota camry

Where is the water pump for a 1992 honda accord and how do you replace it?

You replace it by not doin it

What is the set timing of a 1992 Mitsubishi Expo?

What is the set timing of a 1992 Mitsubishi Expo?

Where can the wiring diagram for a stereo radio be found for a 1992 Mitsubishi Galant?

OK i have a '93 Galant of my girlfriends that I am trying to wire. This is what I found that helped me out the most. Go down to Chrysler/Mitsubishi Joint and it will show you the color in the dash...and the Modern harness color. That helped me alot. Only problem its says is not to use the illuminator or dimmer wires.

How do you replace the water pump on a 1992 Mercury Topaz?

what is the engine?

What is the oil capacity for a 1992 Mitsubishi galant 2.0?

If you are putting in a new oil filter(recommended) with the change, you'll need 4 qrts. A good 3 and a half qrts. if you are leaving the old dirty filter in.

When was Mitsubishi Lancer Evolution created?

Mitsubishi Lancer Evolution was created in 1992.

Why would 1992 Mitsubishi galant pulsate when idling?

tps out of adjustment. Must be adjusted using a voltmeter. Basic idle set screw ( BISS) out of adjustment. Ignition timing incorrect. vacuum leak. good luck

People also asked