answersLogoWhite
Water Pumps
Dodge Durango
Nissan 300ZX
Nissan Pathfinder

How do you replace the water pump on a 1992 Nissan 300ZX?

767778

Top Answer
User Avatar
Wiki User
2006-05-09 02:25:22
2006-05-09 02:25:22

first remove the fan and shrould. then the radiater and hoses. next remove the thermostat housing. remove the harmonic balancer(27mm or 1 1/16 shallow socket).remove all timing cover bolts(upper and lower). remove driver's side timing cover and move passenger side cover up just a bit to allow lower cover to be removed. a little tricky on the lower drivers side. may have to remove coolant temp sender and coolant temp sensor on the other pipe. no need to remove timing belt

1

Related Questions

User Avatar

For your 1992 Nissan/Datsun 300ZX: Flywheel Torque 61-69 Foot pounds (Final torque)

User Avatar

yes if the turboengen is the right size

User Avatar

its on the passenger side silver with a black cap.

User Avatar

I'm 99.6% sure there isn't one designed into the system.

User Avatar

The fuel pump is inside the fuel tank, which is accessed from inside the trunk.

User Avatar

It is located on the center, top, rear of each cylinder head.

User Avatar

http://www.300zx-twinturbo.com/cgi-bin/manual.cgi not sure if this is for a Nissan 92.

User Avatar

You have to remove the upper intake to even get to the fuel rail. make sure you have all the o-rings seals and gaskets in between cause you should replace them. Really its worth it to take the car to a mechanic.

User Avatar

Try cross referencing starter numbers from 240SX's and in some cases, the Pathfinder.

User Avatar

it is on the passenger side of the block where it meets the transmission....right down behind intake....

User Avatar

http://www.ehow.com/how_7744525_change-injectors-1994-nissan-maxima.html

User Avatar

how do you install a water pump on a 1992 toyota camry

User Avatar

That is a statement with a question mark attached to the end, not a question. do you want to know what to do about it, why it doesnt work, or something else?

User Avatar

my 92 Nissan has a belt make shure that its abelt and not a chain

User Avatar

loosen adjuster bolts and take off belt......

User Avatar

u need to replace the flasher unit in the vehicle

User Avatar

you only need to remove the auxillary drive belt to un-bolt and rplace the water pump (this is on the 2.0 16v twin cam SR20 motor.

User Avatar

You will need to remove the tire and wheel from your 1992 Nissan Stanza. Remove the brake pad spring and caliper. The brake assembly will come off. Reverse the process to install the new brake pads.

User Avatar

Attached to engine block right under alternator

User Avatar

E.C.C.L. CRUISE CONTROL! In Nissan!


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.