answersLogoWhite
Water Pumps
Pontiac Grand Am
Grand Am SE

How do you replace the water pump on a 1992 Pontiac Grand Am 3.3L V6?

525354

Top Answer
User Avatar
Wiki User
2015-07-15 20:05:31
2015-07-15 20:05:31

take the rear header off and disconnect the exaust from the header pull the senser out of header the pull header completely out the unbolt the water pump from the timing chain and then from the block then from the hard hose on the bottom of pump(6 bolts)all together then remmove water pump then put net gasket between pump and all other hoses and re install all of the compnents removed

1

Related Questions

User Avatar

When I first realized I had to change the water pump in my Grand Am it looked pretty daunting and I wasn

User Avatar

How do you replace the ignition swith opn a 1992 Pontiac Bonneville se

User Avatar

Yes, a 1992 Pontiac Grand Am does have a timing belt. Diagrams can be found of them on the internet with a simple search.Ê

User Avatar

Empty it, unhook the hoses and wires then unbolt the straps holding it on.

User Avatar

autozone.com has online manuals that give step by step how to

User Avatar

how to replace a serpentine belt on 1992 grand am 2.3l

User Avatar

The answer is too involved to answer here. Buy a repair manual ($12) at most auto parts stores. There you will find detailed instructions.

User Avatar

how to chang spark plugs in a 1992 Pontiac grand prix

User Avatar

you pay somebody to do it for you...I have one mostly apart in the garage now.

User Avatar

The water pump is located on the passenger's side of the vehicle near where the engine belt is located (on a 3.3L engine). It seems to be a little difficult to get to. Have always had someone else replace my water pump don't know how difficult it is to replace.

User Avatar

I just replace my daughters water pump in a Grand AM GT with a 3.3 V6, it cost me about $32.00

User Avatar

1992 Pontiac grand am ac relay locationi found the relays. they are in the center of the firewall next to the blower case. they are in a case with cover that is bolted to the firewall.

User Avatar

The switch is on the steering column about 18 inches from the floor under the dash. There are 2 screws that hold it on.

User Avatar

There was more than one size used on the 1992 Pontiac Grand Am depending on which model it was GT, etc. It should be listed on the drivers door post. If not click the link I will post.

User Avatar

yes it should bolt right up as well as the original motor and tranny

User Avatar

Purchase a service manual for this car, the procedure will be clearly explained.

User Avatar

To answer this i will need to know whatsize engine you have.

User Avatar

No. From 1992 to 2008 (final model year), the Pontiac Grand Prix was a front-wheel drive vehicle. Prior to 1992, the Grand Prix was rear-wheel drive. The Grand Prix was never an all-wheel drive vehicle.

User Avatar

It dep[ends on exctly which engine you have as to how difficult it is, Get a manual you your car and do the job correctly .

User Avatar

If you are talking about the signal flasher it is tucked up under the dash on the drivers side. There only a few bucks. Happy Wrenching.

User Avatar

Yes It would if its 2.3L engine size. Also, fits Oldsmobile Achieva of same year. Thanks

User Avatar

how do you install a water pump on a 1992 toyota camry


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.