How do you replace the water pump on a 1993 Chevy half ton 5.7L?
Probably one of the easiest but you need direction. Get a manual on your car from DISCOUNTAUTOREPAIRMANUALS.COM
Drain down the radiator using a large clean drain pan. Remove top half of fan shroud. Remove accessory drive belt. Remove fan assembly. Remove water pump pulley. Remove lower half of fan shroud. Remove water pump. Clean gasket surface area. Install in reverse order. Not knowing what engine you have this is a general answer.
I have a 08 Chevy Cobalt. It took me about an hour and a half to replace the crank position sensor. Disconnect your battery and unbolt your starter; you can leave the starter wired up just move it out of your way. The sensor sits behind the starter. Be careful when disconnecting the plug for the sensor so you don't break it. You can disconnect is from up top so you can see what you're…
Water Pump 94 passport The water pump is located under the timing belt covers and is a nightmare to replace if you are a common do it your self mechanic.The top and front half of the engine has to be removed.Take it to a Honda dealer and have them replace the timing belt and the water pump at the same time. Two birds in one stone helps save money!
Would it be easy for someone who isn't a mechanic to replace the serpentine belt on a 2004 Chevy cavilier?
Where is the fuel tank sender module located on a 1997 Chevy half ton pickup and how do you get to it to replace it?
If this is 1 4.2L, it's cake. Three hours book time, but you can do it in half that. Remove the belt, then the radiator and fan and fan clutch. See that big flat bracket now? Yeah take it off. Put a new water pump on, reassemble, and fill the coolant. Drive the vehicle for 20 minutes, then check the transmission fluid level. You're now done.