Ford Probe
Water Pumps
Nissan Pathfinder

How do you replace the water pump on a 1993 Ford Probe GT?

262728

Top Answer
User Avatar
Wiki User
Answered
2011-09-12 21:06:14
2011-09-12 21:06:14

You gotta go in there and locate the water pump first... use your manual by the company "chilton" designated for your vehicle model...

you need the adjustable wrench. go in thera nd undo the screws on the water pump and watch out for the belts that go through there. take it out and bring to your autoparts store and get the new one...

put it in the reverse way from taking out the old one. good luck. the instructions are also in your cars manual, and you can now also get a computerized version of the manual for any car online, ordered on CD ROM, from eBay or ther web sites...

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


diagram of starter in a 1993 ford probe

Replace the chain and both the cam and crankshaft gears.

Replacing the water pump is an extremely difficult task. I would recommend buying a new vehicle, and selling me the old one.

ford probe gt rims are 7 inch

Were do I locate the fuel filter on a 1993 Ford probe 4 cylinder

Refer to this: http://home.comcast.net/~mmunoz70/z/leskatimingbelt.doc

its a Mazda engine . ( DOHC 4cyl. 16 valve 2.0l ) For the probe 1993

In the alternator. Have to replace the Alternator.

Yes it is possible with a bellhousing adaptor plate..... but in short no......Buy the right tranny......or a flux capacitor......

Follow the top radiator hose down to the water outlet on the engine; it is in the water outlet. Mark

Yes,but the 93 and 94 enginges are obd1,while the 95-97 are obd2.

no it is not , your looking approx. 8.5 hrs in and out to replace a probe transmission....

Follow the top radiator hose down to the water outlet on the engine; it is in the water outlet.

it is located inside the fuel tank

---- ---- == == ---- == == ---- == == ---- == == ---- ---- == == ---- == == == == == == == == == == == == == == == == ----

Brand New 1993 Ford Probe right off the show room floor cost me "$29 800.00"

Roughly $800.00 parts & labor. This figure could easily double if done by a dealer.

how do I replace a fuel pump on a 1993 Ford Bronco 302 5.0 L

you buy one or take it to the shop

Easy: you call a professional to do it. The Probe windscreen is bonded directly to the car and is not a job for the DIY-er.

if the 94 probe is a GT, yes. the 2.0l alternators are different from the GT the autozone part numbers for the 94 2.0L Probe is 14449 and the part number for the 94 2.5L GT is 14450

The 1993 Ford Probe rear brake light lens cannot be removed. The tail light are a complete seal light. The light bulb's can be removed from the rear of the light assembly.

It is important to check and maintain the fluid levels while owning a car. The transmission dipstick of a 1993 Ford Probe is located behind the engine, to close to the firewall and it has a yellow cap.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.