answersLogoWhite

0


Best Answer

buy a repair manual,because you have to take a few things off to replace the water pump including the timing belt,which should also be replaced.gmjim

User Avatar

Wiki User

โˆ™ 2005-09-17 22:23:44
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you replace the water pump on a 1993 Toyota Camry?
Write your answer...
Submit
Related questions

What would it cost to replace the clutch on a 1993 Toyota Camry?

The estimated cost for parts and labor to replace the clutch on a 1993 Toyota Camry is between $1,260 and $1,687. This can be higher or lower depending on where a person lives.


Where is the fan belt on a 1993 Toyota Camry station wagon?

Replace valve seal


What is code 21 for 1993 Camry?

what is a code 21 on 1993 Toyota Camry 4cyl


How much would it cost to replace the glass moon roof on a 1993 Toyota Camry?

Contact the dealership for an estimate.


Where is fuse box on 1993 Toyota Camry?

how do you check to know whether your coolant fan motor needs replacing in my 1993 toyota camry v6?


Need fuel line diagram for 1993 Toyota Camry?

i need a digram on gas lines on a Toyota Camry


Warning lights that appear on the dash of a 1993 Toyota Camry?

There are several warning lights on the dash board of a 1993 Toyota Camry. There is a hot water warning, a low voltage warning, a low fuel warning, and several others.


Where is the heater core located on a 1993 Toyota Camry and how difficult is it to replace it?

Passenger side, near the firewall. It is not difficult to replace, it is just very difficult to get to.


How much oil goes in for an oil change on a 1993 2.2L Toyota Camry?

4.5 quarts if you replace the oil filter.


How can I replace the power steering pump on an 1993 Toyota Camry wagon with v6 engine?

In replacing the power steering pump on a 1993 Toyota Camry wagon with V6 engine, make sure to replace the steering pressure hose and clamp also. The leaks on both the hose and the clamp are the cause of the broken power steering pump.


Is The 1993 Toyota Camry An OBD1 or OBD2?

OBD1


Thermostat location on 93 Toyota Camry Vienta?

On a 1993 Toyota Camry Vienta, the thermostat can be easily located by following the lower radiator hose to the point where it attaches to the engine. When replacing the thermostat, always replace gaskets as well.


Where is the ignition fuse located for a 1993 Toyota Camry?

The 1993 Toyota Camry ignition fuse is located in the fuse box. The ignition fuse will be in the first column, fourth from the top.


How much gearbox oil in a Toyota Camry 1993?

The 1993 Toyota Camry gearbox holds nine quarts of gear oil. The manufacturer recommends that you never overfill the gearbox.


How do you install a timing belt on a 1992 Toyota Camry?

How do you install a timing belt on a 1993 Toyota Camry that has a 2.2 liter engine


What are the timing marks for 1989 Toyota Camry?

timing marks 1993 yoyota Camry 2200


Where is the starter located on a 1993 Toyota Camry?

The starter on a 1993 Toyota Camry is located on the driver's side of the motor. It is so low that it is almost underneath the motor, back near the firewall.


Need repair manual for 1993-Toyota Camry free?

i think Toyota nation forum has all of them 1993 and up.


What are the factory settings for a 1993 Toyota Camry?

Factory settings of what?


What kind of freon does a 1993 Toyota Camry require?

R134A


What is the oil capacity of a 1993 Camry with 3 L engine?

The engine oil capacity of a 1993 Toyota Camry V6 is 4.3 quarts.


What is the Freon for 1993 Toyota Camry wagon?

It is usually written on the compressor.


Spark plug gap 1993 Toyota Camry LE?

0.043


What is the engine size of a 1993 Toyota Camry CL?

4 engine


What is the recommended tire pressure of a 1993 Toyota Camry LE?

30