First you must drain the coolant. Remove powersteering pump[keep hoses connected)this is just to make room for water pump removal so just sit it off to he side.Loosen the the water pump pulley mounting bolts, remove the drivebelt,remove the pump pulley. Remove the pump mounting bolts and pul the pump from engine.Install every thing in reverse ,but be sure to clean the mating surface of old sealer and gasket first, also be sure to use RTV gasket sealer on engine side of the new gasket.Be sure not to over/under tighten the bolts the torque specs. are 22 to 29 for the long bolts and 96 to132 for short bolts and 108 to 132 ft lb for the pulley bolts.
remove and replace water pump in 1997 Oldsmobile aurora
lower the engine from the car
is it hard to replace a waterpump out of a oldsmobile aurora 95
water pump has some (2) pins into the block...it needs to be pryed stright off.
We replaced ours and it cost 21.95 for a lifetime water pump.....My husband replaced it by himself...
maybe this will help,,, i just replaced the water pump,heater core,thermostat,battery,alternater on my Oldsmobile and found this site to be very helpful even has pictures AutoMedia.com maybe you can find your answer there good luck
Remove the serpentine belt then remove the water pump bolts and any attached hoses. It would help to know what year, model, or engine size.
To change the water pump simply remove the bolts from the waterpump, pull it off and replace with new. The power steering pump will need to be loosened and moved aside to remove one bolt. Clean old gasket from engine block and replace with new gasket and replace with new waterpump.
There seems to be two parts to the water pump and the fan is what usually goes first. Olds. was smart enough to just male that part to replace only. I was replacing the alternator on my 91 and decided to replace the water pump part I was speaking of. It's cheap and easy to get to. Hope this helps in some way.
Oldsmobile didn't make a 4.3 in 2000
is it hard to change the water pump on a 1992 Oldsmobile achieva. Yes, it is very hard to replace a water pump on an Achieva. When the pump died on my 1996 Achieva, the engine needed to be unbolted and removed to get to it. As I recall, it cost about $500. I have a 95 Olds Achieva 3.1 and the water pump was very easy to change. Mine is on the front passenger side of the engine. Very easy to get to, just be careful not to break any bolts off. lol
2.3L quad 4 is located under the exhaust manifold passenger side. To replace you have to remove the exhaust manifold.
The Oldsmobile AleroThe vehicle that replaced the Achieva was Oldsmobile Alero (produced from 1999-2004).
JC Whitney and Parts Geek both carry the water pump for a 1991 Oldsmobile Calais.
The 2001 Oldsmobile water pump is located on the front of the engine. You can follow the top radiator hose directly to the water pump.
remove the window washer and radiator fill bottles by pulling upwards and lay them aside. Remove the serpentine belt. You will see the water pump connected to the large hose going to the radiator. remove and replace.
first lose the belt the the four ten mm bolt and you move the pully and lose the six 5/16 bolt
You must remove the exhaust manifold it's easy to do once this is done.also the front timing cover need to be removed because the water pump driven by the chain.
the thermostat is located where the top radiator hose attaches to the engine. there are three bolts that take off the water neck that the hose attaches to. remove those bolts, the thermostat is inside.
Royal Institute of Painters in Water Colours was created in 1831.
replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo 6 cylinder
the water pump ,the radiator or a pluged thermostate will do this is your engine making a squeeking sound if so replace water pump if you blow a head gasket its expensive to fix the water pump should cost under 40 for the part
Replace water pump and gasket
It varies by engine.