answersLogoWhite

0


Best Answer
Copy

There are too many steps to enter it all here. Your best bet would be to get a Haines manual. I used one to do my 95. Make sure you read the steps first before doing the work. Unfortunatly you have to take a lot off to do this.

BEFORE YOU DO ANYTHING, MAKE SURE YOU HAVE A BUCKET OR SOMETHING TO CATCH THE COOLANT!!!! IT WILL SPILL OUT.... AND DO NOT REUSE THE COOLANT, JUST BY SOME NEW COOLANT...

Actually there are not to many steps, what you are going to want to do is remove the drive belt, (there will be 2 the belt on the outermost side is for the Power Steering, the inside belt is for your alternator and water pump), then remove the inside belt. the water pump is behind the pully just under the power steering pump. you'll want to remove the pully from the water pump as the new one often doesn't come with one, then remove the pump, this should be 3 to 4 bolts around the pump. SAVE THESE BOLTS!!! remove the old pump and make sure to remember what way it set in, put in the new one, PUT THE PULLEY ON AFTER YOU BOLT IN THE NEW PUMP... put the pulley back in place, make sure all bolts are tight but not to tight...put the belts back on and make sure they are properly tightened... add your coolant and start it up... wam bam your all set...GOOD LUCK!!!!

User Avatar

Wiki User

โˆ™ 2010-04-12 20:04:46
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you replace the water pump on a 1995 Ford Probe 4 cylinder?
Write your answer...
Submit

Related Questions

What transmissions and years are compatible with 1995 ford probe gt 2.5 6 cylinder turbo?

The 1995 Ford Probe, either the GT or the 4 cylinder DID NOT COME with a Turbo.


Is it possible to replace a automatic transmission in a 6 cylinder 1995 ford probe with a 5-speed 4 cylinder 1993 ford probe?

Yes it is possible with a bellhousing adaptor plate..... but in short no......Buy the right tranny......or a flux capacitor......


How do you replace the slave cylinder on a 1995 dodge neon clutch?

How do you replace a slave cylinder on a 1995 dodge neon clutch


How much would it cost to install a water pump in a 1995 Ford Probe 4 cylinder?

a 4 cylinder probe im not sure but i got the gt model and they want 600-800 from places i checked at so probably around 300-400 for yours


Can 4 cylinder be replace with 6 cylinder in 1995 jeep wrangler?

Yes


Where is the fuel filter located and how do you replace it on a 1995 Ford Probe?

look at the passinger side of the bay its towards the bulk head below a black plastic breatihg cylinder i believe mate


Is the power train control module of a 1993 probe gt 2.5 v-6 compatible with 1995 ford probe 2.0 4-cylinder?

no it is not. simply because you can't swap a 6cylinder computer with a 4 cylinder


When should you replace the water pump on a 1995 Jeep Wrangler 4 cylinder manual transmission?

The water pump does not have a specified life span. The time to replace it is when it is leaking or noisy.


Instructions for replacing a master cylinder in a 1995 C1500 GMC Sierra?

how do i replace the maser cylinder on a 1995 GMC Sierra


How do you replace the water pump on a 1995 Mercury Mystique?

Depends if it is the 4 cyl or V6 its a 4 cylinder it is a 4 cyl


How do you change the master cylinder on a 1995 Buick regal with ABS?

how to replace master cylinder on 1996 buick regal


What is the firing order for a 1995 Ford Probe 4 cylinder?

According to the manual, 1-3-4-2. Cylinder numbering from left to right, looking at the engine from the front.


Where do you pour clutch fluid in 1995 probe?

The 95 SE has an hydraulic-assist clutch that is slaved off of the brake master cylinder.


How hard is it to replace a water pump on a 1995 Nissan quest 3.0 mini van?

how to replace water pump on Nissan quest 3.0 1995


Where is the location of a water pump on a 1995 buick skylark 4 cylinder?

The location of a water pump on a 1995 Buick Skylark 4 cylinder is next to the engine. It is found directly under the alternator.


Will a 1995 Ford Probe transmission fit in a 1994 Ford Probe?

yes....


How do you replace the water pump on a 1995 Chevy Corvette?

== ==


How do you fix a faulty master brake system on a 1995 Honda Accord?

If the Master Cylinder is defective then replace it.


Will a sunroof from a 1995 Ford Probe GT fit into a 1994 Ford Probe SE?

Yessir, it will.


How do you replace water pump in 1995 Buick roadmaster?

To replace the water pump in the 1995 Buick Roadmaster, begin by first removing the pins that hold the water pump drive to the water pump. Then, pry the timing cover off of the water pump area.


What do you do if the key is stuck in the igniton of a 1995 Plymouth Neon and it will turn the car on and off but not come out?

this is caused by ignition lock cylinder failure, you will have to replace the ignition lock cylinder and key.


Where is the voltage regulator on a 1995 Dodge Ram?

how do you replace voltage regulater on dodge ram van 150 6 cylinder


What is the bolt pattern on a 1995 Ford Probe?

5x114.3


How do you go around the amp on 1995 ford probe how do you go around the amp for after market radio?

how do you go around amp for after market radio on 1995 ford probe


What do you use to remove the cylinder heads on a 1995 Ford Probe GT?

YOU NEED 12MM 12 POINT 3/8 DRIVE DEEP IMPACT SOCKET. NAPA HAS THE SET YOU NEED