Dodge Intrepid

How do you replace the water pump on a 1996 Dodge Intrepid?

585960

Top Answer
User Avatar
Wiki User
2015-07-14 15:07:24
2015-07-14 15:07:24

You have to take out the electric fans. then take off the belts and then you will have to pull the hurmonic balancer off take the timing cover off then take off the timing belt. the water pump is located in between the cams it is bolted on with 3 boltsand looks like a pully. this is for a 1996 dodge intrepid with the 3.5 v-6 you

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Where can I get a diagram of a 1996 Dodge Intrepid cooling system?

User Avatar

diagram for timing marks on 1996 dodge intrepid 3.5

User Avatar

its a in tank fuel filter replace the sock on the fuel pump

User Avatar

Which do you mean? African or European Intrepid?

User Avatar

Dodge does not use inertia/reset switches.

User Avatar

It is an integral part of the starter.

User Avatar

Yes. You can use automatic transmission fluid in the power steering on a Dodge Intrepid.

User Avatar

3.3L, it is external and driven by the serpentine belt. 3.5L it is internal and driven by the timing belt.

User Avatar

The 1995 Dodge Intrepid does not have and ODB2 port, the Intrepids didn't introduce ODB2 until 1996.

User Avatar

You have to remove the pan, there is no drain.

User Avatar

The 1996 Dodge Intrepid main bearing torque specification is 180 pounds. The main bearings should be torqued in 60 pound intervals.

User Avatar

No, it will not, design is much too different to make it feasable. For a 2000 intrepid you must use a 1998-2001 engine. Check out dodgeintrepid.net for a ton of info on these cars.

User Avatar

If same size engine, yes.If same size engine, yes.

User Avatar

3.3L has a chain. 3.5L has a belt.

User Avatar

the plastic around the radio pops off.. there is 3 bolt head screws that hold it in, remove them radio slies out. unplug and done.

User Avatar

On the passenger side bell housing on the near the transmission.

User Avatar

On a 1996 Dodge Intrepid, the flasher button is located near the center back of the steering wheel, you should see the button on the top of the steering column. The flasher itself is mounted to the multi purpose fuse panel.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.