Chevy Blazer S-10

How do you replace the water pump on a 1997 Chevy Blazer S-10?

282930

Top Answer
User Avatar
Wiki User
Answered
2006-08-29 00:54:37
2006-08-29 00:54:37

buying a chilton or haynes repair manuel for the s series blazer will help in knowing how to change it

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


how to replace a heater core in a 1997 Chevy blazer

The average cost to replace your 1997 Chevrolet Blazer water pump is $230. The water pump will cost approximately $80 and require two hours of labor.

How fast are you going? Fast speed = more gas burned per mile. Slower speed = less gas burned per mile.

Will a 1997 blazer what work on a 1999 blazer????? If your talking engine, transmission, or running gear than yes. It is all the same.

The 4.3 liter V6 engine in a 1997 Chevy Blazer has a timing CHAIN

I have a 1997 Chevy Blazer 4DR and the relay is located underneath the glove box.

a 4 door 97 blazer front how do i do it

The 1997 Chevrolet Blazer didn't come with a cabin filter.

Freon is R12. Your 1997 Chevy uses R134 Refrigerant.

this is incorrect. The fuel pump is located in the fuel tank. It is a lot of work to replace. I have done it twice on my 97 blazer. Its expensive too around 300 bucks. The fuel pump on a 1997 Chevey blazer is right beside the engine

yopu have to have a special tool to do it .

If the turn signal bulbs light but will not flash, the flasher relay is defective, replace it.

i am looking for a diagram of the firing order in a 1997 Chevy s10 blazer 4x4.

how to install time chain cover on a1997 blazer

your heater core is going out, you need to replace it before it ruptures.

You can replace Chevy Blazer 1997 and similar models with BMW's 7 series rims, and vis versa. I had 740IL rims from my cousins car on my Chevy 1997 Blazer 4x4 for 3 years and they worked great. I can only assume the brake parts on the GM cars are German made components, and this was why. No need to modify anything. They go right on and are a perfecr fit.

we are trying to find regular factory wheels that fit the lug pattern off of a 1997 Chevy blazer s-10 2 wheel drive

the 1996 and 1997 are the same and would not work in your 2000 straight from GM

1997 s-10 blazer has shocks,on both front and rear.

to replace the intake gasket would be about 4 hours labor. parts would run about $50

The 1997 Chevrolet Blazer OBD 2 port is on lower edge of dash; right of parking brake

The 1997 Chevrolet blazer actuator switch is located on the firewall in the engine compartment. The switch is on the passenger side of the engine compartment.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.