answersLogoWhite
Mercury Sable
Water Pumps
Dodge Durango

How do you replace the water pump on a 1997 Mercury Sable?


Top Answer
User Avatar
Wiki User
2011-09-12 21:06:54
2011-09-12 21:06:54

first take of wire cover on top to give yourself more room then take off serpetean belt by taking a 15mm wrench to the tentioner and turn it clockwise to loosen belt then take off hose leading out the front of car the take off hte bracket thatthat holds a/c compressorbolts are 10mm them take off the nuts to water pump. before youcan get to hte lower hoses you must take off the front iner fenderwell. whatch out the heaterhose is a bear to get the clamp off. i took the big lower hose off first and then from top tyrned the water pump so i could get the clamp off for the heater hose needlessto say i change the clamp for a regular screw clamp once your there you can easily manuver the water pump out reverse to install.

Related Questions

User Avatar

A 1997 Mercury Sable takes the ( # 9007 headlight bulb )

User Avatar

The 1997 Mercury Sable does not have a timing belt, it has a timing chain that normally requires no replacement and should last the life of the engine.

User Avatar

Where is the starter located on a 1997 mercury sable ,and if any display a photo of the part.

User Avatar

According to the 1997 Mercury Sable Owner Guide ( 16.0 U.S. gallons )

User Avatar

For a 1997 Mercury Sable : ( DOT 3 brake fluid meeting Ford specification ESA-M6C25-A )


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.