answersLogoWhite
Ask
Water Pumps
Dodge Durango
Oldsmobile Intrigue

How do you replace the water pump on a 1998 Oldsmobile Intrigue?

697071
Answer

Top Answer
User Avatar
Wiki User
2011-09-12 21:07:02
2011-09-12 21:07:02

It is very easy! Take off belt by putting a wrench or socket on tensioner pully and rotating it. belt will come right off. You will have to drain coolant. then take out all of the bolts holding the water pump on. you will have to remove the power sterring pump to get to the very back bolt. Make sure you clean old gasket off of the motor and install new gasket with sealer. reassemble in reverse order.

On '98s at least there is an access hole in the p/s pulley that gives you access to that last bolt

I found no access hole except through the power steering which was easier to remove than the PS pully that a pully remover does not have sufficient room. Two bolts top and bottom through the access holes for the PS pump and it is out of the way of the last water pump bolt.

12
0

Related Questions

User Avatar

you take the old one out and replace it with the new one... hope this helps

User Avatar

The Oldsmobile Intrigue does not have a timing belt. It uses gears. For cars that do have a timing belt, about 60,000 miles. But remember than some engines don't use one.

User Avatar

The 1998 Oldsmobile Intrigue gets an estimated 19 mpg in the city. The vehicle gets an estimated 30 mpg highway mileage.

User Avatar

The Antenna is built into the rear window.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.