Chevy Suburban
Chevy Tahoe
Water Pumps

How do you replace the water pump on a 1999 Chevy Suburban?

868788

Top Answer
User Avatar
Wiki User
2011-09-12 21:07:07
2011-09-12 21:07:07

I replaced the water pump on my 99 Suburban in 2003. It was a fairly simple job. The water pump on a 1999 Chevy suburban can be removed once you remove the radiator fan. Here is a way to remove the fan clutch withouy a fan clutch tool. The trick is to leave the belt on and tight. Take a 1 7/16 inch wrench and put it behind the fan onto the big shaft nut attaching the fan to the water pump. Put it straight up and crack it counterclockwise with a hammer. This should loosen the nut. After that just spin the fan off and the rest is easy. Make sure you clean the old seal off of the engine. It is small and easy to miss.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

How do you replace a starter in a 1999 suburban

User Avatar

I have the check engine light on and the code is for map sensor on my 1999 1500 Chevy suburban

User Avatar

I have a 1999 Suburban-JB6 brakes. The drum size is 11"

User Avatar

I have a 1999 Chevy Suburban LT and if I stay at the recommended hwy speed I easily get 19mpg

User Avatar

The 1999 Chevy Suburban camshaft sensor is located on the front of the engine. The camshaft sensor will be behind the front engine cover.

User Avatar

Remove the belt from your 1999 Chevy Metro water pump. Remove the water pump return hose. Remove the water pump retaining bolts. Reverse the process to replace the water pump.

User Avatar

dig a very large whole and roll that p.o.s. into it and bury it. boom. done.

User Avatar

rear door-remove the door panel. back speaker carefully pry off grille cover and replace speaker

User Avatar

change low beam lite in 1999 suburban

User Avatar

A 1999 Chevy Suburban needs a tune-up every 25,000 miles. This ensures the vehicle operates at peak efficiency at all times.

User Avatar

No you can not. Theres no way to remove it from the top of the tank when the body is in the way.

User Avatar

where is the oil pressure switch on a 1999 chevy surburban

User Avatar

1999 Chevy Suburban 1500 LS, 5.7 litre gasoline engine... 44 gallon fuel tank

User Avatar

The tail light bulb on a 1999 Chevy Suburban is replaced by removing the retaining screws, pulling the bulb assembly away from the vehicle, and unscrewing the bulb. A new bulb can then be installed and the assembly screwed back in place.

User Avatar

On mine, its behind the dashboard instrument cluster.

User Avatar

A person must leave the right size gap for the spark plugs when changing them. The 1999 Chevy Suburban has a spark plug gap of .060 inches.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.