Water Pumps
Dodge Intrepid
Nissan Pathfinder

How do you replace the water pump on a 2000 Dodge Intrepid?

232425

Top Answer
User Avatar
Wiki User
Answered
2006-08-22 05:16:38
2006-08-22 05:16:38

as you look directly at the engine in front look down rigth behind the belts, this is a big job remove belts ,pulley, tensioner, you will see a y like shape cover remove all bolts ,remove cover,guess what you're there. I would highly recamend replacing the timing belt at the same time ,if you did not replace it yet usally around 70,000-100,000 replace it all or you're looking for major problems and which could includ new heads timing belt goes so do vlvs ,springs ech.

012
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


I need detailed information on how to replace a starter for a 2000 dodge intrepid

Faulty fuel injector.......had to replace 2 on my 2000 Intrepid...Good Luck

yup i have a set off a 2000 on my 97 they fit perfect

On the 2.8 it's on top of the plenum at the back. disconnect the hose & unscrew the pcv valve & replace.

how do you remove the flasher relay in a 2000 dodge intrepid. I got it unplugged but don't know how to remove it

The spark plug gap for a 2000 Dodge Intrepid measures .050 inches. This is the equivalent of 1.2 to 1.3 mm.

Dodge does not use inertia/reset switches.

Dodge doesn't use inertia switches.

No, it will not, design is much too different to make it feasable. For a 2000 intrepid you must use a 1998-2001 engine. Check out dodgeintrepid.net for a ton of info on these cars.

The only fuel filter on a 2000 Dodge Intrepid is part of the pump module in the fuel tank.

I have checked the fuse and relay. How do I reset the A/C on my 2000 Intrepid

how to change oil pressure switch in 2001 Dodge Intrepid I need to look at a diagram

Yes, 2nd Generation Intrepid was made from 1999 through 2004 IDENTICAL Cars Actually, it was 1998 through 2004.

Dodge does not use inertia/reset switches.

The thermostat on a 2.7L Dodge Intrepid is under the housing where the lower radiator hose attaches to the engine.

In the 1998 Intrepid ES, 1684 indicates a problem with the catalytic converter. It probably is the same for the 2000.

The starter on a 2000 Dodge Intrepid 3.2 L is located on the driver's side of the motor. It is way down low next the fly wheel area.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.