The answer will cost you a commitment to post the next thing you can't find on here but figure out yourself. Stop reading if that is too much to ask. :)
Pull the three screws from the door panel. Pull the door panel up and off. It has a couple of hooks at the bottom that will come out when you pull the whole thing up. Don't worry about pulling the wiring loose just pull a couple of the plastic retainers out so you have more room to work. Pull the sound insulation (starting at the bottom) loose about a foot up and tape it out of the way. Swing the door panel back toward the rear of the door and hook the top on the door lock. Remove two of the 5/16ths screws holding the motor on. One through a small hole, and the other through a triangle already cut in the door frame. The third is a trick to get to. You can use a small wrench from the bottom but I drilled a hole in the door frame so I could get a socket in. Reach in and pull the motor loose by shaking it. It is still attached by a rivet that you'll have to drill out but pull it loose so you know which rivet to drill.
Good luck and don't forget your commitment.
Yes
HOW DO I REPLACE WINDOW REGULATOR MOTOR ON PASSENGER SIDE WINDOW
How do you replace a power window motor ( rear passenger side ) in a 2002 Ford Explorer
how do I replace the passenger side window regulator on an E250, 2006. the window will not release to push to top of window frame only half way?
go to your local machanic
The motor could be burnt out on the window. This is more than likely what has happened. The motor can be replace for a low cost.
video on how to replace window lift motor on j30
http://www.ford-forums.com/ford-ranger/11517-procedures-replacing-power-window-motor-ford-ranger.html Try this link.
How to remove the window motor from the regulator
well iam a retard you have take off the door panel to get to the motor but to replace the window switch get a flathead sd and stick it under the front of the switch holder and lift up
the wheels
replace a window lift motor for a 2002 gmc sierra?