0
How do you replace throwout bearing on 1991 ford ranger5 speed?
Wiki User
∙ 17y ago
You will have to pull your tranny off, your throwout bearing is in the bell housing (front part of your tranny) while your in there it would be a good idea to check your clutch as well as your pressure plate. Good Luck Drive Safe
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you replace throwout bearing on 1965 Ford Falcon xp 3 speed?
lube up the pivot points on all your cables first jesse.
Why would your 5 speed 1999 ford escort make a rattling noise when you put it in gear?
Possibly bad throwout bearing
Your 2001 corolla heater fan rattles on all but high speed How do you fix or replace it?
bearing is out,replace motor.
How do you replace the speed sensor on a 2002 Pontiac Grand Am?
most likely you will have to replace the hub bearing assembly autozone for about $80
How do you change a rear wheel bearing on a 2000 Pontiac Montana?
You need to replace the rear wheel hub - bearing and speed sensor inclusive
How do you remove and install throw out bearing on a 2003 Honda Accord coupe 2.4 liter 5 speed?
The short answer: Pull the transmission and put a clutch kit in it. A Honda Accord clutch kit comes with the clutch disc, pressure plate, and a new throwout bearing.Once you get the transmission out, the throwout bearing is slid onto the transmission input shaft and is connected to the clutch arm. You unhook it from the clutch arm, slip it off the shaft and put the new one in its place.
How do you replace vt commodore rear wheel bearing?
To replace a rear wheel bearing of a VT Commodore, remove the hub from the car and press it in and out. The bearing has an inner and outer seal. The inner seal has a magnet for the abs sensor. Make sure to install the new bearing before the abs will pick up a speed fault.
What do you do when the throwout bearing sticks when trying to pull the transmission on a 2003 Hyundai Tiburon GT 6 speed?
Remove the clutch lever off the top of the transmission and reinstall upside down then rotate counterclockwise as you pull the transmission out. To install do the process backward.
How do you Replace front wheel studs on 2000 Montana?
You replace the wheel bearing hub assembly - it has studs, bearings and wheel speed sensor around $100 part
What is the average price for replacing 1994 Acura Legend clutch?
A lot. The Acura Legend has one of the most expensive replacement costs for a clutch I've ever seen. Suppliers that carry the pats are few and far between, and the parts alone range from $350-$950 for the clutch & $400-$700 for the flywheel (depending on 5 or 6 speed design). The throwout bearing is about $150 as well. Then factor in about $350-1000 for labor, depending on who you know and how good they are at what they do. Personal advice: if you have a 6-speed and need the clutch / flywheel / throwout bearing replaced, use a 5-speed instead. The flywheel is lighter for better fuel economy, and clutch feel is better. It's also cheaper, too.
How do you remove a speed sensor on 2004 Chevy Colorado?
If it is 4x4 remove axle from wheel bearing assembly and then remove the wheel bearing assembly. Make sure the tone ring (looks like a ring with teeth) is still attached to the spped sensor side of the bearing, if not, replace wheel bearing assembly with an assembly that comes with the speed sensor. Replacing a speed sensor without a tone ring is pointless because it won't work.
Can you replace a speed sensor on a 1998 Chevy Blazer without replacing the whole hub and bearing assembly?
yes you can but good luck finding one
