answersLogoWhite

0


Best Answer

GM seriously over-complicated something which should have been so simple. You can only get to the light through an access panel located in the shroud under the front bumper. Because the car sits so low to the ground, this requires you to jack the car up (always use jack stands), and then remove the two screws on the access panel and fold it out of the way. You then have to reach up inside the bumper to the back of the light. Squeeze the tab on the side of the socket and twist the socket to remove it from the turn signal housing. The light bulb itself can then be pulled straight out of the socket without twisting.

.

update, 2009

I just managed to change the turn signal light using a foot long screwdriver to push in the tab on the socket while simultaneously pushing on the other side of the socket with the two fingers that could just touch the socket opposite the tap. Look to the side of the headlight housing and you can just see the socket. It is on top of the light housing for the turn signal and the bulb sticks down. You will need to remove any watch and roll up your sleeves to reach the housing. I also pushed sideways with the screwdriver while holding in the tab with the screwdriver. Once it broke free is was easy to turn and remove and replace with a new bulb.

Same same on my 2000 Camaro.

I first used my phone camera and flashlight to get a good view of what I was feeling with the fingertips. Then with small flashlight resting on frame rail I could just see the goal (view between headlight housings). The foot long screwdriver goes through this peep hole, press the tab, push c'clockwise, 1/8 turn and presto it was loose. Note, flat blade screwdriver must be oriented so it holds tab down AND pushes sideways. Oriented the other way it slips off the tap. Socket can also be viewed looking almost horizontal from center line of car. Good luck! Change both while your at it.

User Avatar

Wiki User

8y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

14y ago

Well turn your lights on and determine which bulb is not working. Take off the plastic cover to that bulb's housing. Remove locking ring, pull bulb straight out from carrier housing and install new bulb making sure to secure it in the locked position, reinstall locking ring. Of if all else fails you can drop your car off at the dealership and they will only charge u about 40 dollars to put it in. Takes about 50 seconds to do.

This answer is:
User Avatar

User Avatar

Wiki User

12y ago

2002 Volkswagen Passat turn signal bulb replacement: Purchase the correct replacement bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).

This answer is:
User Avatar

User Avatar

Wiki User

12y ago

2005 Pontiac Montana front signal light bulb replacement: Purchase the correct replacement bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).

This answer is:
User Avatar

User Avatar

Wiki User

12y ago

2004 VW Volkswagen Golf tail light bulb replacement: Purchase the correct replacement tail light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the tail light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).

This answer is:
User Avatar

User Avatar

Wiki User

8y ago

Look in the owners manual. It will show you how. If you don't have the owners manual, go to the VW web site and download it.

This answer is:
User Avatar

User Avatar

Wiki User

14y ago

take it to the garage

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace turn signal indicator on a 2002 vw passat wagon?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace a taillight bulb on a 2004 VW Passat wagon?

unscrew it and screw in the new bulb


How do you replace radiator water on 2003 passat wagon?

unplug line at bottom of overflow or bottom of radiator


How do you replace the batteries in a keyless remote 2004 Passat Wagon?

You can always take it somewhere and have them change them for you, places such as cartronics.


Does VW make a diesel Passat wagon?

Volkswagen does not make a diesel version of the Passat wagon for sale in the United States. They have made a Volkswagen Passat BlueMotion Diesel that is or soon will be available in Europe only, however that is not a wagon.


MY volks wagon passat 2000 has 107239 mile does the timing belt need to be replace?

Yes and if the belt breaks it will damage your engine.


Which fuse do i need to replace so my signal lamps work on my 1987 volks wagon cabrio?

Probably a BAD TURN SIGNAL FLASHER


Is there a glovebox in a 1996 passat wagon?

yes there is and it has a light =)


What is the towing capacity of a 2007 passat wagon?

3300


Where is the starter on a 2001 VW Passat wagon?

where is the starter located in a 2001 VW Passat. GLS 1.8 V6


Does the VW Passat Wagon use diesel or gas?

The 2010 Volkswagon Passat Wagan uses a gasoline engine.


What is the right oil for an 01 passat wagon V6?

The 2001 Passat wagon uses 5.7 pints of oil to 6.5 oil. Do not overfill as that may cause overflow to damage the catalytic converter.


2004 passat computer location?

In the 2003 Passat Wagon (US), it is under the carpet directly in front of the driver's seat.