answersLogoWhite

0


Best Answer

You replace the valve seals on a 1996 Saturn SL1 by removing all of the hardware to get to the valves, unseating them, cleaning them, and sliding the new valve gaskets on. In order to do this you should consider getting a good Chiltons or other repair manual for your make, model, year, and engine.

User Avatar

Wiki User

โˆ™ 2013-10-15 17:12:06
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you replace valve seals in a 1996 Saturn SL1?
Write your answer...
Submit
Related questions

Picture of theEGR valve in a 1996 Saturn?

see saturnfans.com


Why would a 1996 Saturn SL1 be blowing smoke after first starting It will be fine once into 3rd and after that?

Valve guides or seals could be worn allowing oil to build up and be sucked in to combustion chamber


What is wrong when you have oil inside the spark plug guides on a 1996 Saturn?

There could mean that the rings on the pistons are worn. Oil on the top of the plugs means the valve cover, or tube seals have failed.


Cant figure out if your 1996 jaguar van den plas has coil gaskets or valve cover spark plug seals?

Jaguars have plug seals.


Can you replace a 96 Saturn engine with a 92 Saturn engine?

YES BUT. YOU SHOULD USE THE 1996 CRANKSHAFT AND THE 1996 INTAKE SO YOU NEED TO DISASEMBLE BOTH ENGINE TO DO ONE


Is it recommended to replace rear axle seals but not the bearings on a 1996 Chevy S-10 4wd?

It would be recommended to replace the rear axle bearings and axles when they are worn/bad. If the bearings and axles are okay, just replace the seals.


How do you replace a EGR in a 1996 Saturn SL1?

The EGR valve is located on the drivers side of the head, just above the transmission bell housing. Remove the electrical and vacuum connections, then remove the two bolts that hold the EGR valve to the head. Use a NEW gasket when replacing the EGR valve.


Valve cover gasket on a 1996 Saturn twin-cam sl2?

.....what about it? There is one. Dealer has premolded ones also


Where is the pcv valve on a 1996 Saturn SL1 and how do you replace it?

I have an SL2 and the it is part of the valve cover. Small 1/2" hose comes from air box and goes to it on the valve cover. If you purchased your new one it might also help you locating it. It is located on the valve cover next to the oil cap just pull it out with some moderate force and pull the hose off by twisting it.


Where is the PCV valve on a 1996 Buick Park Avenue and how do you replace it?

It is in the intake behind the throtle body. Simply pull it out and replace it.


Intermittent starting 1996 Saturn?

Solenoid going bad remove and replace starter assembly.


Where is fuel pump in a 1996 Saturn?

Inside the fuel tank.Removal of the tank is necessary to replace the pump.


Where is the PCV valve in a 1996 jeep wrangler and how do you replace it?

PCV valve is on top of one of your valve covers and it should just pull out there should be a big rubber line on it


How do you replace 1996 Chevy lumina egr valve?

remove the 2 bolts andharness


How do you replace 1996 Saturn timing belt?

how do i change timing chain on 95 saturnsc1 1.9 sohc


How do you repair a 1996 Saturn head gasket?

The only repair for a blown head gasket is to replace the gasket.


How do you replace transmission fluid in a 1996 Saturn?

Drain the fluid just like you would the oil. replace the filter the exact same way also


What is the torque spec a 1996 Saturn valve cover?

DOHC cover is 89 in-lbs SOCH cover is 22 Ft-lbs


How do you replace the egr valve on a 1996 Chevy sliverado?

In front of the radiator between the grill and the radiator


How do you remove and replace the AC expansion valve on a 1996 S10 6-cylinder Chevy Blazer?

Remove the bottom hose from the evaporater at the firewall, pull out the expansion valve, i highly recommend flushing out the system to remove excess sludge. Replace the valve and the hose.


When you first start your 1996 Toyota Camry 4-cylinder will not idle?

You need to replace the EGR valve. Make sure to replace the plugs too after that.


How do you replace the front turn signal light bulb on a 1996 Saturn SC2?

rear you use a torx driver to remove taillight assembly screws. them replace bulb.


How do you fix a leak in the fuel pressure regulator of a 1996 Pontiac Sunfire?

fuel press. regulators often leak because the seals dry out. it is easy to replace the regulator and it should come with new seals.


Where Is The Low Pressure Side Valve On 1996 Saturn SC1?

Larger hose from a/c compressor may be near the drier on the passenger side firewall


Does the 1996 Saturn SL2 fender fit the 1996 Saturn SC2?

NOT AT ALL