Buick Electra

How do you replace your heater core in your 1976 Buick Electra you am not sure how to access the heater core?

444546

Top Answer
User Avatar
Wiki User
2009-01-13 01:29:01
2009-01-13 01:29:01

According to Haynes: Warning: Engine must be completely cool prior to doing this! 1. Disconnect negative battery cable. 2. Drain the cooling system. 3. Disconnect the heater hoses from the heater core tubes @ firewall. 4. Remove heater case nuts from engine side of firewall. 5. Remove dashboard trim panels and the instrument panel pad. 6. Detatch lower air duct & defroster duct from heater unit. 7. Disconnect & label everything from heater unit. (label so you know where to put them back to) 8.remove the heater case-to-dash nuts/bolts & pull case back until studs clear the firewall, remove entire unit from vehicle. 9. Seperate heater case, remove core retaining screws & remove core from case. 10. Installation is reverse of removal. Make sure any damaged seals are replaced & seal the case with caulking. Good Luck!

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The heater core is mounted to the passenger side firewall on the 1988 Buick Electra 307. The blower motor needs to be removed to access the heater core.

User Avatar

It should be behind the glove box in an access panel.

User Avatar

replace heater core on 92 buick century

User Avatar

how much would it cost to replace the heater coil on a 1999 buick leSabre

User Avatar

How do I replace heater core on 98 Buick lesabre

User Avatar

take one end of your heater hose off the heater core and run it back to the intake port.

User Avatar

hubcaps.org and serious wheels.com have good pictures, but for the most options, go to Google Images (www.google.com/images), type in "Buick Electra" and you'll have access to dozens of photos in seconds.

User Avatar

I need to know how do i replace a haeter core on a 1994 buick park avenue?

User Avatar

A fully fueled 75 Buick Electra 4door custom weighs 5080 lbs.

User Avatar

replace the water heater inlet pipe on the intake manifold on a 3800

User Avatar

The heater CORE is a big job. Get a manual on your car to do the job correctly.

User Avatar

Not practical to try to fix a heater core. Replace it with a new one.

User Avatar

To replace the lights in your car you need to unscrew the headlight cover on your Buick. Once this is removed you can unscrew and replace the old bulb.

User Avatar

how do i tighten the steering column on a 89 buick park avenue electra

User Avatar

buick firing order3.8 electra

User Avatar

The Buick Park Avenue nameplate was first used in 1977 on a model of Buick Electra, but did not exist as a standalone model until 1991, when it replaced the Electra.

User Avatar

To repair a seat heater on a 2004 Buick LeSabre, disconnect the connector and check for voltage. If there is no voltage, replace the switch. If there is voltage, check for an open circuit.

User Avatar

right side fender under the hood, the horn is easy to access and replace

User Avatar

Buick Century Buick Electra Buick Lacrosse Buick LeSabre Buick Lucerne Buick Park Avenue Buick Regal Buick Riviera Buick Roadmaster Buick Skylark

User Avatar

Open the drivers door and look at the side of the dashboard. This is your access to the fuse box.

User Avatar

Pretty much all parts are interchangeable from a 75/76 Electra

User Avatar

Edsel, Buick "Electra",


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.